$10.99
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you've been running your Commander hot or dealing with brass flying too far downrange, this is the spring that solves that problem. Ed Brown's 20lb Commander recoil spring is built specifically for the 4.25-inch Commander slide and designed to keep the slide closed a bit longer during the firing cycle, which tames ejection distance and improves reliability under demanding conditions.
That extra two pounds over the factory 18lb spring makes a real difference when you're shooting +P ammo or running your gun hard. The 20lb rate is Ed Brown's recommended upgrade for commanders being pushed beyond standard pressure loads. It maintains constant spring rate throughout compression, so you get predictable performance shot after shot. This spring is round-wire, high tensile strength spring steel that'll give you years of reliable service without losing its temper.
When a recoil spring is too light, brass ejects way too far, which is both annoying and hard on your gun's frame and internals. Get it right, and you'll see spent cases land 8-12 feet downrange—a sweet spot that tells you the spring weight is dialed in for your load. A properly matched spring also reduces battering wear on your frame and helps prevent reliability hiccups that come from over-ejection.
Ed Brown recommends replacing your recoil spring every 3,000 rounds or so, depending on what you're shooting. That's just good maintenance. This spring drops right into your existing guide rod and plug with no gunsmithing.
Ed Brown recommends replacing the recoil spring every 3,000 rounds, though you can watch for signs of wear like loss of length or increased felt recoil. When the spring shortens by more than about three coils or feels noticeably softer, it's time to swap it out. Springs under stress lose their temper over time, so regular replacement keeps your gun running reliably.
The 20lb spring is heavier than factory spec (which is usually 18lb) and works best if you're shooting +P ammunition or heavy loads. If you run standard pressure loads exclusively, an 18lb spring handles that fine. Pick based on what you shoot—proper spring weight keeps brass ejecting at the right distance and maintains reliability.
This spring is designed to work with standard recoil spring guides and plugs found on most 1911 Commanders. It's a drop-in replacement that doesn't require any modifications or gunsmithing. Just make sure you're using a conventional round-wire spring setup, not a flat-wire system.
The extra two pounds means the slide stays closed a touch longer before cycling back, which reduces how far brass travels downrange and improves handling of heavier loads. Standard factory ammo runs fine with 18lb springs. The 20lb is better for +P loads or if you want less rearward brass scatter.
| UPC | 800732920009 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 920-C |
| Model |
You must be logged in to post a review.
Reviews
There are no reviews yet.