$24.75
9 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Anyone who has fought a stiff mil-spec takedown pin with cold or greasy fingers knows the drill. The Yankee Hill Machine EZ Pull set fixes that with two oversized heads that give you a real grip on both the front pivot and rear takedown pins. You grab, pull, and your upper and lower separate without hunting for a punch or a stray cartridge to poke them loose. It is one of those small upgrades that you don't fully appreciate until the first time you break the rifle down at the range and everything just works.
These are machined from steel, heat treated, and plated to mil-spec, so they hold up to repeated takedowns and swaps. The grab heads run about .480 inches wide, which is enough to work with gloves on or if your hands aren't what they used to be. The set is built for standard mil-spec lowers and drops in using your existing detents and springs, so there's no special hardware to source. A lot of builders end up putting a set on every lower they own once they try them.
This pin set shines on a dedicated lower that sees a lot of upper swaps, or any rifle you clean often. The oversized heads do stick out past the receiver more than standard pins, so they're less at home on a slick, snag-free carry build where a low profile matters. If you run a fixed-mag setup, the easy-to-reach rear pin also makes opening the action a lot friendlier on the fingertips.
Installation is a straightforward drop-in job that most people knock out in about ten minutes. Pull your current pins to full extension, retract the detents with a small pick, push the old pins out while retaining the detents, then seat the new EZ Pull pins. Just keep a thumb over that spring-loaded front detent so it doesn't launch across the bench and disappear into the carpet.
They're designed for standard mil-spec AR-15 lower receivers and install as a drop-in swap using your existing detents and springs. Some tighter or non-standard lowers can run a little snug, which many people actually prefer since it helps tighten up upper-to-lower fit. If you're running a proprietary or unusually spec'd lower, it's worth double-checking your receiver dimensions first.
Yes, most folks knock it out in about ten minutes with basic tools. Pull your current pins to full extension, use a small pick to retract the detents, push the old pins out while keeping the detents captured, then seat the new EZ Pull pins. Keep a thumb over the spring-loaded front detent so it doesn't launch off the bench.
The heads do stick out past the receiver more than standard pins, which is exactly what makes them so easy to grab. On most rifles they don't interfere with normal shooting or handling. They're less ideal on a low-profile carry gun where you want nothing to snag, but on a range or workhorse build they're a non-issue.
If you swap uppers or clean your rifle often, the difference is night and day since you can separate the receivers by hand instead of digging for a punch. The steel construction and mil-spec plating hold up to repeated takedowns. Plenty of builders end up putting a set on every lower they own once they try one.
| UPC | 816701015119 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 7284 |
| Color | Black |
| Length | 5.1000 |
| Model | |
| Product Type | Takedown Pins |
You must be logged in to post a review.
Reviews
There are no reviews yet.