$81.99
15 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Anyone who has ever slipped a hardware-store screwdriver out of a tight receiver screw and left a nasty burr behind knows why a proper gunsmithing set matters. The Wheeler 89-Piece Professional Gunsmithing Screwdriver Set (2023 Edition) tackles that problem head-on with hollow-ground flat bits that seat all the way into the slot for maximum contact. Wheeler's engineers measured screws on over a hundred modern and antique firearms while building this lineup, so there's a bit to fit just about everything from a Remington 700 to a Smith & Wesson revolver to an old Colt single action.
Inside the custom-molded case you'll find 54 hollow-ground flat bits, 15 specialty bits, 8 Allen bits, 4 Phillips (#0 through #3), and 3 Torx (T10, T15, T20). The specialty bits cover the odd stuff that usually sends you hunting for a one-off tool, including Weaver and Ruger scope ring clamp bits, Redfield and Leupold windage screw bits, a Mauser stock cross bolt bit, and the Ruger/Colt single action base pin latch nut bit. There's also a 2-1/4 inch shaft extension and a hex-to-square drive adapter tucked in for good measure.
Every bit is machined from S2 tool steel and finished in black phosphate to fight rust and stretch out the tool's life. The hollow-ground grind means the tip stays parallel where it meets the screw slot instead of tapering like a common wedge-shaped driver, which is what keeps it from camming out and marring your gun. Both the short and long 1/4-inch drivers carry rubber over-molded handles and magnetized tips, so bits swap fast and stay put while you work.
The hinged case includes a bit location guide so you always know where each piece lives, and it's built to stack alongside other Wheeler sets on the bench. Whether you're mounting optics, adjusting a stock, tightening grips, or doing a full teardown, this is the kind of set that lives on the workbench and earns its keep.
The flat bits are hollow-ground, meaning the tip stays parallel where it contacts the screw slot instead of tapering to a wedge like a common driver. That flush fit spreads the load across the whole slot and keeps the bit from camming out and burring up the screw head. On a firearm, where a marred screw is both ugly and hard to fix, that extra contact is the whole point.
No, this kit does not include a torque driver. It comes with two standard magnetized 1/4-inch drivers, the bit assortment, an extension, and an adapter. If you want to torque scope rings or action screws to spec, Wheeler's FAT Wrench is a separate tool that uses the same 1/4-inch bits.
That's exactly what it's designed for. Wheeler measured screws on more than a hundred modern and antique firearms when they laid out the bit selection, so you'll find sizes for guns ranging from a Remington 700 to a Colt single action. The 15 specialty bits also cover things like scope ring clamps and windage screws that trip up a lot of generic sets.
The bits are machined from S2 tool steel and hardened to 56-58 Rockwell C, so they hold up to real use on stubborn fasteners. Every bit and driver shaft wears a black phosphate coating that resists corrosion and helps the tools last. Keeping them in the fitted case between jobs goes a long way too.
| UPC | 661120747055 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 4001008 |
| Color | Black |
| Length | 11 |
| Model | |
| Product Type | Kit |
| Shipping Weight | 3.97 |
| Style | 89-Bits |
You must be logged in to post a review.
Reviews
There are no reviews yet.