$29.99
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Recoil management on a pistol usually means picking between a bulky compensator that ruins your holster fit or nothing at all. Tapco split the difference with this 2-Port Micro Brake, a short, low-profile brake built specifically for 9mm handguns running a 1/2×28 threaded barrel. It's small enough to keep your gun feeling like a gun, not a science project bolted to the front end.
The design is simple and that's the point. Two vent ports cut into the brake redirect gas upward and to the sides as the round leaves the barrel, which helps counteract muzzle rise and keeps your sights tracking flatter between shots. On a 9mm, felt recoil is already manageable, but a lot of shooters notice quicker sight recovery once this brake is threaded on, especially when running steel challenge or just putting rounds downrange for practice.
Tapco finishes this brake in a black nitride coating over the steel body, which gives it solid resistance to holster wear, moisture, and the day to day abuse that comes with carrying or range use. The nitride finish also matches the black finish on most factory and aftermarket 9mm barrels, so it doesn't stick out or look mismatched once it's installed.
Threading is standard 1/2×28, which covers the vast majority of aftermarket threaded 9mm barrels on the market. Because the brake itself is so short, it adds minimal length to your slide, so most shooters find their existing holster still works or only needs a minor adjustment. Keep in mind you'll want a threaded barrel already installed and a thread protector or crush washer setup to keep everything indexed and tight before you head to the range.
This brake is cut for a standard 1/2×28 thread pattern, which is the most common threading found on aftermarket 9mm pistol barrels. Double check your barrel's threading before ordering since not every threaded 9mm barrel uses this exact pitch.
It helps redirect muzzle gas to counteract flip, so most shooters notice flatter sight tracking and a bit less perceived recoil compared to shooting without any device. On a 9mm the difference is more about faster sight recovery than dramatic recoil reduction, since 9mm recoil is already mild to begin with.
Because it's built short and compact, it adds very little length to the end of your slide compared to a full size compensator. Many shooters find their existing holster still works fine, though it's worth test fitting since holster tolerances vary.
No special tools are required beyond a wrench to thread it on once your barrel is already threaded 1/2×28. Just make sure it's torqued down properly and indexed straight so it sits flush and centered on the bore.
| UPC | 810122800064 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | TAP22006 |
| Model | |
| Thread Pattern | 1/2"x28 |
You must be logged in to post a review.
Reviews
There are no reviews yet.