Description
The Rise Armament Micro Hand Stop is one of those small parts that changes how a rifle feels in your hands. It clamps to any M-LOK handguard and gives your support hand a consistent place to index, which helps with recoil control and keeps your grip repeatable shot to shot. Best of all, the reversible design means you get two functions out of one tiny piece of hardware.
Two Sides to the Micro Hand Stop
One face has an ergonomically curved surface that acts as a comfortable brace point for your hand, letting you drive the gun and pull it into your shoulder. Flip it around and the flat side works as a barricade stop, giving you something to load against when you're shooting off a wall, post, or barricade edge. Because you can run it either way and stage it at the front or rear of a slot, there's plenty of room to dial in a grip that fits your hands and shooting style, gloves on or off.
Built Light, Built Tough
Rise machines this from 7075 T6 aluminum with a skeletonized profile, so it adds less than an ounce to your handguard. You'll barely notice the weight, but you'll feel the added control. The Patriot Blue anodized finish holds up to handling and gives an otherwise all-black build a bit of personality.
Getting the Micro Hand Stop Dialed In
Installation is about as simple as it gets. Pick your M-LOK slot, set the hand stop at the front or rear of that slot, and tighten the single screw with the included Allen wrench. One tip worth knowing: don't center it in the middle of a slot or it won't clamp down properly and will slide. Position it at either end and it locks in solid. At just over three quarters of an inch tall and under an inch long, it stays out of the way until you want it, making it a great pick for a lightweight AR pistol or carbine setup.
Key Specifications
- Manufacturer: Rise Armament
- Model: Micro Hand Stop
- Manufacturer Part Number: RA030BLU
- UPC: 850011713228
- Color: Patriot Blue (Anodized)
- Material: 7075 T6 Aluminum
- Design: Skeletonized, Reversible
- Compatibility: Any M-LOK Handguard
- Weight: 0.2 oz
- Height: 0.75 in
- Length: 0.96 in
- Width: 0.6 in
- Mounting: Single Screw
What’s Included
- Rise Armament Micro Hand Stop (Patriot Blue)
- M-LOK mounting hardware
- Allen wrench
Frequently Asked Questions
What handguards does the Micro Hand Stop work with?
It's built for any standard M-LOK handguard, so if your rifle or pistol runs M-LOK slots you're good to go. Just pick your slot, set the stop at the front or rear of it, and tighten the single screw. It won't work on KeyMod or Picatinny rails without an adapter.
Why is my Micro Hand Stop sliding after I install it?
The most common cause is placing it in the middle of an M-LOK slot, where it can't clamp down properly. Position it at the very front or rear edge of the slot instead and it will lock in solid. Give the screw a firm final tightening and it'll stay put.
What's the difference between the two sides of the hand stop?
One side has a curved, ergonomic surface that gives your support hand a comfortable brace point for pulling the gun into your shoulder. The other side is flat and works as a barricade stop when you're shooting off cover or a support. Since it's reversible, you just flip it to whichever setup you prefer.
How much weight does the Micro Hand Stop add to my build?
Thanks to the skeletonized 7075 T6 aluminum construction, it adds less than an ounce, right around 0.2 oz. You get the improved control and index point without any real weight penalty. It's a great option for keeping a lightweight AR pistol or carbine trim.




Reviews
There are no reviews yet.