Description
The Redding Type S Neck Bushing Die for .300 PRC gives handloaders precise control over case neck diameter and neck tension, which is where a lot of the accuracy in a precision load really comes from. Instead of sizing the whole neck down and then opening it back up with an expander, you pick a bushing that sizes the outside of the neck to exactly the diameter you want. For a long-range cartridge like the .300 PRC, that kind of consistency pays off on paper.
How the Type S .300 PRC Die Works
The die accepts interchangeable sizing bushings sold separately in .001 inch increments, so you can set your neck tension right where it needs to be for your brass and your application. A common starting point is to measure the outside neck diameter of a loaded round and subtract about .002 inches to allow for brass spring-back. The bushing floats slightly inside the die body, which lets it self-center on the case neck and helps keep runout low. Bushings for this die fall in the .331 to .339 range for the .300 PRC.
Dialing In Neck Tension With the Redding Bushing Die
The adjustable decapping rod lets you position the bushing to size only part of the neck if you want, which some reloaders prefer for a little extra case support at the shoulder. The rod comes with a standard size button, handy if you are running commercial brass as-is. A decapping pin retainer is also included for folks who sort or neck-turn their brass and want to size without the expander button at all.
Redding builds these dies from quality steel, machined to tight tolerances and heat-treated for a long service life. The die threads into any standard reloading press with 7/8-14 threads, so it drops right into most setups. Keep in mind bushings are not included, so grab the sizes you need for your brass when you order.
Key Specifications
- Caliber: .300 PRC
- Die Type: Type S Bushing Neck Sizing Die
- Manufacturer: Redding
- Manufacturer Part Number: 71776
- UPC: 611760717765
- Bullet Diameter: 0.308 in
- Bushing Range: 0.331 in to 0.339 in
- Bushing Increments: .001 in
- Material: Steel, heat-treated
- Press Thread: 7/8-14
- Shellholder: #6 (sold separately)
- Country of Origin: USA
- Shipping Weight: 0.815 lb
What’s Included
- Type S bushing neck sizing die body
- Adjustable decapping rod with standard size button
- Decapping pin retainer
- Lock ring
- Instructions
Frequently Asked Questions
Does the Redding Type S Neck Bushing Die come with bushings?
No, the die ships without bushings. Redding sells them separately in .001 inch increments, in both steel and titanium nitride, so you can pick the exact neck tension you want. Most reloaders keep two or three sizes on hand to cover different brands of brass.
What bushing size do I need for .300 PRC?
Measure the outside neck diameter of a loaded round and subtract about .002 inches to account for brass spring-back. For the .300 PRC, bushings in this die generally fall between .331 and .339 inches depending on your brass and bullet. If your neck wall thickness varies a lot, you may want to go a touch smaller and let the size button finish the inside diameter.
Will this die work in my reloading press?
Yes. It uses the standard 7/8-14 thread, so it fits virtually any common single-stage or turret press. You will also need a #6 shellholder for the .300 PRC, which is sold separately.
What is the advantage of a bushing neck die over a standard neck die?
A bushing die sizes the outside of the neck to a precise diameter instead of oversizing and then expanding it back out. That reduces how much the brass gets worked, helps keep runout low, and gives you dialed-in, repeatable neck tension. For precision and long-range loads, that consistency often shows up as tighter velocity spreads.





Reviews
There are no reviews yet.