Description
If you're loading 6mm ARC for a gas gun, this RCBS AR Series set takes the guesswork out of getting rounds that run. It's a two-die package made specifically for semi-auto platforms, pairing a small base sizer with a taper crimp seater so your handloads chamber and cycle the way factory ammo does.
The small base sizer is the heart of this set. It works the brass down a touch smaller than a standard full-length die, which matters a lot when you're feeding rounds through an AR's bolt and chamber under speed. That extra sizing at the case base is what keeps cartridges dropping in and locking up without a fight, round after round.
What the RCBS 6mm ARC AR Series Set Brings to the Bench
The taper crimp seater is the other half of the equation. Instead of a roll crimp, it uses a 7-degree taper crimp angle that RCBS designed for autoloading rifles. That crimp holds the bullet firmly so it won't get pushed back into the case or walk out under recoil and the hard knocks of magazine feeding. For semi-auto use, where bullet setback can be a real headache, a good taper crimp is worth its weight.
Fit and Build on the RCBS AR Series Dies
These dies use the standard 7/8"-14 thread, so they'll thread right into any common single-stage or progressive press. Like the rest of the RCBS lineup, they're machined to tight tolerances, hardened, and finished to hold up to years of use on a busy bench. They ship in RCBS's black die box to keep everything protected and organized between sessions.
One thing worth knowing up front: a shellholder is not included, so if you don't already have the right one for 6mm ARC on hand, grab one to go with the set. Beyond that, this is a straightforward, dependable way to feed a 6mm ARC gas gun with ammo you built yourself.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 28007
- UPC: 604544670400
- Caliber: 6mm ARC
- Product Type: Small Base / Taper Crimp
- Number of Dies: 2
- Die Types: Small Base Sizer, Taper Crimp Seater
- Crimp Style: Taper Crimp
- Crimp Angle: 7 degrees
- Thread Size: 7/8"-14
- Shellholder Included: No
- Carbide: No
- Country of Origin: USA
What’s Included
- Small Base Sizer Die
- Taper Crimp Seater Die with bullet seater plug
- Black RCBS die storage box
Frequently Asked Questions
What makes the RCBS AR Series small base die different from a standard full-length die?
A small base die sizes the case base a bit smaller than a standard full-length die does. That matters for semi-autos because an AR cams a round into the chamber fast and under force, and the tighter sizing keeps cartridges chambering reliably. If you're running a gas gun, a small base die is usually the safer bet for consistent feeding.
Does this 6mm ARC die set come with a shellholder?
No, a shellholder is not included with this set. You'll need the correct shellholder for 6mm ARC to use the dies on your press. If you don't already have one on your bench, pick one up along with the set.
Why does this set use a taper crimp instead of a roll crimp?
The taper crimp seater uses a 7-degree angle that RCBS built specifically for autoloading rifles. It holds the bullet firmly without the setback or walk that can happen during semi-auto feeding and recoil. A taper crimp works well with jacketed bullets that don't have a cannelure, which is common for 6mm ARC loads.
Will these dies fit my press?
Yes, the dies use the standard 7/8"-14 thread found on common single-stage and progressive presses. They'll thread right in with no adapters needed. The set works well for both bench loaders and anyone running a progressive setup.





Reviews
There are no reviews yet.