$150.00
10 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
There is a real appeal to the way Q approaches suppressor mounting. Instead of ratcheting latches or spring-loaded collars that wear out and collect carbon, the Plan-B ASR uses a simple taper-on-taper interface. This version threads into SilencerCo Charlie/ASR pattern suppressors, so cans like the Saker 762, Saker 556, Saker 556K, Omega 36M, and Chimera 300 can lock straight onto Q's Cherry Bomb muzzle brake. Two twists and your can is seated the same way every single time.
The magic is in the matched tapers. One lives on the Cherry Bomb brake, the other inside the Plan-B mount, and when they mate up you get a big contact surface that self-aligns the suppressor and holds tight under fire. That extra surface area means better bore alignment and more consistent point of impact shift than typical fast-attach systems. It also shields the threads from carbon, so the mount comes off clean instead of baked on. There are no shims, crush washers, latches, or springs anywhere in the system, and you never have to time the muzzle device.
This mount is machined from heat-treated 17-4 stainless steel with a black finish, and it only adds about 2.3 ounces and roughly two tenths of an inch to your setup. That is barely noticeable on the end of a rifle, which matters when you are already hanging a suppressor out there. Install is refreshingly simple too. Thread it into your can, torque it down with the wrench that shipped with your suppressor, and you are done.
If you already run Cherry Bomb brakes on your rifles for a Q can like the Trash Panda or Thunder Chicken, this mount folds your SilencerCo ASR suppressor into that same quick-detach ecosystem. One brake pattern across the safe, any compatible can on any host, no fiddling. It is a clean solution to a problem a lot of multi-suppressor owners run into, and it is built to outlast the hardware it replaces.
This version is cut for the SilencerCo Charlie/ASR pattern, which covers the Saker 762, Saker 556, Saker 556K, Omega 36M, and Chimera 300. If your can uses a different rear pattern, Q makes Plan-B mounts in Alpha, Bravo/Omega, Omega 9K, Ghost, and Tirant versions instead. Double-check your suppressor's mount pattern before ordering.
Yes, the Plan-B is one half of a two-piece system. The mount threads into your suppressor and then locks onto the taper of a Q Cherry Bomb muzzle brake installed on your barrel. Without a Cherry Bomb on the host rifle, the mount has nothing to attach to.
Remove your existing ASR mount from the back of the can, thread the Plan-B in, and torque it to 35 ft-lbs using the wrench that came with your SilencerCo suppressor. No shims, crush washers, or timing needed. From there the can spins onto any Cherry Bomb-equipped rifle in a couple of turns.
The taper design gives you a large contact surface that self-centers the suppressor and keeps carbon off the threads, so there are no springs or latches to gum up or wear out. It delivers very repeatable lockup and consistent point of impact from one mounting to the next. Fewer moving parts generally means fewer things that can fail over years of hard use.
| UPC | 850000857865 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | PLAN-B-ASR-BLACK |
| Color | Black |
| Model | |
| Mount | Cherry Bomb Muzzle Brake |
| Shipping Weight | 0.16 |
You must be logged in to post a review.
Reviews
There are no reviews yet.