Description
If you already run a MEC 600 Jr. Mark V and want to add .410 to your reloading lineup, this is the shortcut. The 8452410 die set swaps your press over to .410 bore so you can load shells on the bench you already have instead of buying a second machine. It is a parts-swap conversion, not a standalone press, so you need an existing Mark V to put it to work.
What the 600 Jr. Mark V .410 Die Set Covers
This kit handles the full changeover. Inside you get the K.O. bushing, resize ring, deprime punch, reprime punch, wad guide, rammer tube, star crimp head, cam crimp assembly, and the shell holder and drop tube. MEC includes detailed instructions, and most folks have the swap done in roughly 15 to 30 minutes once they have done it a time or two. The components are built from steel and aluminum, which is what you want on parts that see repeated cycles.
Loading .410 With the Mark V Conversion Set
The .410 setup is sized to run both 2½-inch and 3-inch hulls, so you are covered whether you are feeding a single shot, an over/under, or a pump. The star crimp head and cam crimp assembly give you clean, factory-looking folds, and the resize ring keeps your brass heads back in spec for smooth chambering. For anyone shooting a lot of .410 for small game, clays, or just plinking, reloading your own takes the sting out of buying boxed shells, which tend to run pricey in this bore.
A Note on Fit
One thing worth flagging: this conversion is made for the 600 Jr. Mark V. It will not fit the older pre-Mark V 600 presses, so check which generation you have before ordering. If you are running the Mark V, this drops right in and gets you loading .410 in short order.
Key Specifications
- Manufacturer: MEC
- Manufacturer Part Number: 8452410
- UPC: 098489014175
- Model: 600 Jr. Mark V Die Set
- Product Type: Shotshell Die Set
- Gauge: .410 Bore / 410 Ga
- Shell Length Compatibility: 2 1/2" and 3"
- Compatible Press: MEC 600 Jr. Mark V (Mark V only)
- Construction: Steel and Aluminum
- Quantity: 1 Set
- Length: 11.25 in
- Shipping Weight: 0.9375 lb
What’s Included
- K.O. bushing
- Resize ring
- Deprime punch
- Reprime punch
- Wad guide
- Rammer tube
- Star crimp head
- Cam crimp assembly
- Shell holder
- Drop tube
- Instructions
Frequently Asked Questions
Will this die set fit any MEC 600 Jr. press?
No. This conversion set is built specifically for the 600 Jr. Mark V. It does not fit the older pre-Mark V 600 presses, so confirm which generation you own before ordering.
What .410 shell lengths can I load with this set?
The .410 conversion is set up to handle both 2 1/2-inch and 3-inch hulls. That covers the common loads you would run through single shots, over/unders, and pumps chambered for .410.
How long does the gauge conversion take?
Once you are familiar with the process, most people swap out the old die set and install the new .410 parts in about 15 to 30 minutes. MEC includes detailed instructions in the kit to walk you through it.
Is this a complete reloading press or just the dies?
This is a conversion die set, not a standalone press. You need an existing MEC 600 Jr. Mark V to install it on, after which your press is ready to load .410 shotshells.





Reviews
There are no reviews yet.