Description
If you load .44 Magnum and you're tired of fussing with calipers and a hand trimmer, the Lee Precision Quick Trim Die makes case length prep about as painless as it gets. This die body holds each case square and secure while the Quick Trim cutter does the work, trimming your brass to the correct length and chamfering the inside and outside of the case mouth all at the same time. No measuring, no guessing, just consistent cases ready for the next step.
The die itself is cut for the standard 7/8"-14 thread, so it threads right into any press that takes common reloading dies. The case length is built into the die, which means once it's set up you just run your brass and get the same trim every time. Reloaders who batch process .44 Mag brass tend to appreciate how much time this shaves off versus the old cutter and lock stud setup.
Why the Lee Quick Trim Die Earns Bench Space
Case length matters more than folks sometimes think, especially if you're applying a solid roll crimp on heavier .44 loads. Trimming brass to a uniform length keeps your crimp consistent round to round, and consistent crimp means better, more predictable results downrange. Because the die references length mechanically, you get that uniformity without stopping to check every case with a caliper.
What You Need to Run the .44 Magnum Quick Trim Die
Worth knowing up front: this is the die body only. You'll need either the Lee Deluxe Quick Trim Case Trimmer or the Value Quick Trim Case Trimmer to actually do the cutting, and those are sold separately. A shellholder is also required and not included. If you already run Lee's Quick Trim system, this die just drops into your rotation. A tip from experienced users is to keep the cutter lightly oiled and give the die a quick brush-out now and then to keep your lengths tight and the tool cutting clean.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90125
- UPC: 734307901257
- Caliber: .44 Magnum (also works with .44 Special)
- Product Type: Quick Trim Die
- Die Series: Quick Trim
- Thread Size: 7/8"-14 standard
- Dies Included: 1
- Shellholder: Required, not included
- Material: Steel
- Country of Origin: United States
What’s Included
- Lee Quick Trim Die body (.44 Magnum)
- Plastic die storage box
Frequently Asked Questions
Does the Quick Trim Die come with the cutter?
No, this listing is the die body only. You'll need either the Lee Deluxe Quick Trim Case Trimmer or the Value Quick Trim Case Trimmer to do the actual trimming, and those are purchased separately. If you already own one of those trimmers, this die drops right into your setup.
Will this die work in my press?
Yes, the die is cut with the standard 7/8"-14 thread, so it threads into any press designed to accept common reloading dies. It operates like a normal die, holding the case square while the cutter trims to length. A shellholder is required and is not included with the die.
Can I use this die for .44 Special as well as .44 Magnum?
Yes, the .44 Magnum Quick Trim Die covers both .44 Magnum and .44 Special brass, since they share the same case mouth dimensions. That makes it a handy single tool if you load both cartridges. Just trim each to its correct length for the cartridge you're building.
Why should I trim my .44 Magnum brass at all?
Keeping your cases at a uniform length gives you a consistent crimp from round to round, which matters on heavier magnum loads that rely on a solid roll crimp. The Quick Trim Die trims and chamfers in one motion, so case prep stays fast and repeatable. Clean, square case mouths also make bullet seating smoother.



Reviews
There are no reviews yet.