L.E. Wilson Case Holder (Standard) 30-06 Springfield CH-3006

Description

If you run a Wilson case trimmer, the case holder is the piece that makes the whole system sing, and this one is cut specifically for the 30-06 family of cartridges. The CH-3006 is a Standard holder, which means it covers a group of cases that share the same body taper and length: 30-06 Springfield, 25-06 Remington, 270 Winchester, 280 Remington, and 35 Whelen. Instead of gripping the case head like a shellholder, it cradles the brass by its body taper, much like the chamber of a rifle. That design is what gives Wilson trimmers their reputation for cutting cases square and to the exact same length every single time.

How the CH-3006 Holds Your 30-06 Brass

Using it is about as simple as reloading gets. You drop the case into the holder, tap the head lightly on the bench so it seats fully into the taper, then set the holder onto the trimmer rails against the stop. Because the case is referenced off its body and not a pilot or collet, you get repeatable alignment without any fuss. When you're done, a quick rap on the case mouth pops it right back out. This holder also does double duty for primer pocket reaming, inside neck reaming, and deburring when paired with Wilson's Uniform Deburring Tool.

Standard Fired Holder and What That Means

Wilson labels this as a Standard Fired holder, which is intended for fired and neck-sized brass. If Wilson does not make a separate New Case holder for your cartridge, the Standard holder is all you need. Worth knowing before you order if you full-length resize, since the fit is referenced to the brass dimensions after firing.

Built Like the Rest of Your Wilson Setup

This is a tool built to outlast you. L.E. Wilson has been machining case holders and trimmers since 1936, and the CH-3006 carries that same no-nonsense, precision-made quality. Made in the U.S.A., it pairs with any model of Wilson case trimmer and will give you a lifetime of clean, uniform trimming.