$116.16
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The L.E. Wilson Full Length Sizing Die for 243 Win is built for handloaders who care about consistency and want real control over how their brass gets worked. In one pass on a standard 7/8-inch press, it sizes the case body and shoulder back to spec while setting your neck tension with an interchangeable bushing. That bushing-based approach is the big draw here, since it lets you dial in exactly the grip you want on the bullet rather than being locked into whatever a factory expander gives you.
Most standard full length dies pull the neck down with an expander ball, which stresses the brass and can leave neck tension a little hit-or-miss. This die skips the expander entirely and uses a bushing to size the neck from the outside, which means less working of the brass and more uniform tension round to round. You pick the bushing diameter based on your loaded neck measurement and the amount of grip you're after, and swapping sizes is quick when you change bullets or brass. Bushings are sold separately so you can match them to your exact setup.
The die is machined and heat treated to L.E. Wilson's spec, running harder than a Grade 8 bolt, with stainless parts that hold up over the long haul and shrug off corrosion. It comes with an adjustable depth decapping rod so you can fine-tune pin protrusion, plus an extra decapping punch tucked in the box. Note that the decapping assembly handles primer removal only, there's no expander in the system.
This die really shines when paired with an L.E. Wilson case gage, which lets you check headspace and case length so you can set the die to bump the shoulder just enough without overworking the brass. For precision rifle and competition loads where neck tension consistency directly affects how tight your groups print, that kind of control pays off at the target and in the number of firings you get out of each case.
No, neck bushings are sold separately so you can match the diameter to your brass and desired neck tension. L.E. Wilson recommends their own bushings, though Redding bushings will also fit. You select the size by measuring your loaded neck diameter and subtracting for the amount of grip you want on the bullet.
It does not. The neck is sized from the outside using the bushing, which reduces how much the brass gets worked and gives more consistent neck tension. The included decapping assembly handles primer removal only.
Yes. It uses the standard 7/8-14 thread and installs in any common single-stage or progressive press. The adjustable decapping rod lets you set pin depth, and the included lock nut holds your die adjustment in place.
A case gage isn't required, but it's highly recommended. Pairing this die with an L.E. Wilson 243 Win case gage lets you check headspace and case length so you bump the shoulder just enough without overworking your brass, which helps extend case life and keeps sizing consistent.
| UPC | 815145025937 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | FLD-243W |
| Shipping Weight | 0.6 |
You must be logged in to post a review.
Reviews
There are no reviews yet.