Description
If you've been chasing tighter groups and longer brass life, the Redding Instant Indicator takes the guesswork out of setting up your dies. It gives you a quick, accurate way to compare the shoulder position of fired and sized cases, so you can see exactly how much you're bumping the shoulder and set your full-length sizing die to do what you want it to do. The same tool checks bullet seating depth uniformity, which is where a lot of accuracy lives. Keep in mind this is the version without a dial indicator, so you'll supply your own 1" x .001" indicator to complete the setup.
What the 7mm-08 Instant Indicator Measures
Headspace readings run from the case shoulder to the base, which is the number you care about when fine-tuning shoulder bump. Drop a fired case in, note the reading, then compare it to a sized case to see precisely how much your die is moving the shoulder. Dialing in around .002" of bump for your chamber keeps cases fitting right without overworking the brass. You can also use it to check overall case length, trim length consistency, and bullet base-to-ogive measurements once you add the proper bore diameter bushing.
Built for the 7mm-08 and Its Family
This unit is cut specifically for the 7mm-08 Remington, but since the Instant Indicator works off shoulder angle, it can handle a family of cartridges that share the same shoulder geometry. Redding now ships these with the Range Adapter, which lets you take measurements at the bench or out at the range without needing a reloading press. For precision handloaders who batch sort brass and want repeatable results load after load, it's a tool that earns its spot on the bench.
Key Specifications
- Manufacturer: Redding Reloading
- Manufacturer Part Number: 17139
- UPC: 611760171390
- Caliber: 7mm-08 Remington
- Type: Headspace & Bullet Seating Depth Comparator
- Dial Indicator: Not Included (body only)
- Measurement Range: Compares within .001 inch
- Indicator Size Required: 1" x .001" dial indicator
- Range Adapter: Included for use without a press
- Material: Cast Iron
What’s Included
- Instant Indicator body for 7mm-08 Remington
- One bore diameter bushing
- Surface contactor
- Shoulder contactor
- Headspace gauge
- Range Adapter
- Complete instructions
Frequently Asked Questions
Does this Redding Instant Indicator come with a dial indicator?
No, this is the 17139 version that ships without the dial indicator. You'll need to supply your own 1" x .001" dial indicator to complete the tool. If you want the model that includes the indicator, that's the 27139.
What can I measure with the 7mm-08 Instant Indicator?
It compares the shoulder position of fired and sized cases so you can set up your full-length sizing die for the right amount of shoulder bump. It also checks bullet seating depth uniformity, trim length consistency, and helps you sort brass and bullets for uniformity. The headspace reading is taken from the case shoulder to the base.
Will the Instant Indicator work with cartridges other than 7mm-08 Remington?
It's built specifically for the 7mm-08 Remington, but because it references off shoulder angle, it can be used on a family of cartridges that share the same shoulder geometry. Just make sure the case you're measuring matches that shoulder angle.
Do I need a reloading press to use it?
Not anymore. Redding now includes the Range Adapter, which lets you take measurements right at the bench or out at the range without mounting it in a press. That makes it a lot more flexible for load development.





Reviews
There are no reviews yet.