Description
This is the .334 diameter bushing from Hornady's Match Grade line, sized for .30 caliber cartridges and built for reloaders who want real control over neck tension. It drops straight into any Hornady Match Grade Bushing Die, and because it floats inside the die cap, it self-centers on the case neck for concentric sizing every single time. The result is more consistent runout and the kind of repeatability that shows up on paper.
What the .334 Bushing Actually Does
Neck tension is one of those details that separates good handloads from great ones. By swapping to the bushing that matches your brass and bullet combo, you size the neck down just enough to grip the bullet and no further. That means you're not running your case necks through more work than they need, so your brass lasts longer and your velocity spreads tighten up. The .334 falls right in the usable range for standard .308 diameter loads depending on your brass thickness.
Picking the Right Hornady Match Grade Bushing Size
The tried and true method is to take a loaded round, measure the outside diameter of the neck with a micrometer, and subtract about .002 to .003 inches to account for brass spring back. As a rough example, a loaded neck measuring .336 with .002 of tension puts you right around this .334 bushing. Since neck wall thickness varies between brands and even between lots, most experienced reloaders keep a bushing one size above and one below their target on hand so they can fine tune without a second order. If you're running Hornady or Winchester .30 cal brass, the .334 is a common landing spot.
Fit and Compatibility
These bushings share the standard .750 inch outside diameter used across the industry, so in addition to Hornady Match Grade dies they'll work in Redding, Wilson, and RCBS bushing die setups. Install it with the size marking facing up so it's visible in the top of the die, leave the cap slightly loose so it can float, and you're ready to size. It's a small part that makes a big difference once you've got your press dialed in.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 594334
- UPC: 090255593341
- Bushing Diameter: .334 in
- Caliber: .30 Caliber
- Outside Diameter: .750 in
- Type: Self-Centering Neck Sizing Bushing
- Quantity: 1
- Gun Type: Rifle
- Made in USA: Yes
What’s Included
- One (1) Hornady Match Grade Bushing, .334 diameter
Frequently Asked Questions
What die does the Hornady Match Grade Bushing .334 fit?
It's designed for Hornady Match Grade Bushing Dies, available in both full-length sizing and neck sizing styles. Because it uses the standard .750 inch outside diameter, it also fits Redding, Wilson, and RCBS bushing dies. The bushing is sold separately, so it's a direct drop-in for any of those setups.
How do I know if .334 is the right bushing size for my load?
Load a round, measure the outside diameter of the case neck with a micrometer, and subtract about .002 to .003 inches to account for brass spring back. If that math lands you near .334, this is your bushing. Keep in mind neck wall thickness changes by brass brand and lot, so measuring your actual loaded rounds beats guessing.
Why use a bushing instead of a standard sizing die?
A bushing lets you control exactly how much you squeeze the case neck, which sets your neck tension precisely. That keeps you from oversizing and overworking the brass, so your cases last longer and your groups tighten up. The self-centering float design also keeps sizing concentric for better runout.
How do I install the .334 bushing in my die?
Drop it into the die with the size marking facing up so it's visible from the top, then thread the die cap down but leave it slightly loose. That little bit of play lets the bushing float and self-center on the case neck as it sizes. It's a quick swap when you want to change neck tension.




Reviews
There are no reviews yet.