Description
If you run the Hornady Neck Turn Tool and you're working with .338 caliber brass, this is the mandrel that makes it happen. The Neck Turn Tool ships with mandrels for 22 cal, 6mm, 6.5mm, and 30 cal, so anything outside that handful means you need the matching caliber-specific mandrel to do the job right. This one is built for the .338 family, and it drops into the same tool without any fuss.
The whole point of a neck turning mandrel is support and alignment. It slides inside the case neck and gives the cutter something solid to work against, so as the brass rotates the cutter shaves the outside of the neck down to an even wall thickness all the way around. Most fired brass isn't perfectly concentric to start with, so the cutter will take material off the thick side first, and that's exactly how it should work. The result is consistent neck tension, better bullet alignment with the bore, and the kind of repeatability that shows up on paper at distance.
Where the 338 Neck Turn Mandrel Fits In
This is a component, not a standalone tool. It only works inside Hornady's Neck Turn Tool, and that tool only accepts Hornady shell holders and mandrels. If you've already got the system set up for your 6.5 or 30 cal loads and you're branching into a .338 cartridge like the .338 Lapua, .338 Win Mag, or a .338 wildcat, picking up the right mandrel is all that stands between you and turning those necks.
Machined for Repeatable Case Prep
The mandrel is turned from stainless steel with a clean silver finish, so it stays dimensionally stable through long sessions at the bench. Paired with the Neck Turn Tool's cutter head, which adjusts in .0005 inch detent increments or runs infinitely with the detents off, you get fine control over exactly how much material comes off each neck. Chuck the tool to a cordless drill and you can move through a full batch of .338 brass quickly while keeping every case consistent.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 391930
- UPC: 090255919301
- Caliber: 338 Cal
- Material: Stainless Steel
- Finish: Silver
- Quantity: 1 Mandrel
- Type: Caliber-Specific Neck Turning Mandrel
- Compatibility: Hornady Neck Turn Tool
What’s Included
- 1 Hornady 338 Caliber Neck Turning Mandrel (391930)
Frequently Asked Questions
Does the Hornady 391930 mandrel work on its own?
No, this is a component that fits inside the Hornady Neck Turn Tool, which is sold separately. The mandrel aligns and supports the case neck while the tool's cutter does the turning. You'll need the Neck Turn Tool itself along with a Hornady shell holder for your cartridge to put it to work.
Why do I need a separate 338 mandrel for my Neck Turn Tool?
The Hornady Neck Turn Tool comes with mandrels for 22 cal, 6mm, 6.5mm, and 30 cal. Since .338 isn't one of the included sizes, you need this caliber-specific mandrel to properly support and align .338 brass during turning. Using the correct diameter mandrel is what keeps the neck wall thickness uniform.
What calibers will this 338 mandrel cover?
It's sized for .338 caliber case necks, so it works across the .338 family including cartridges like .338 Lapua Magnum, .338 Win Mag, and various .338 wildcats. As long as the case uses a .338 projectile, this mandrel is the right one to support the neck while turning.
Can I use a drill with the Neck Turn Tool and this mandrel?
Yes. The Hornady Neck Turn Tool is designed to accept a standard cordless drill, which speeds up turning compared to doing it by hand. The mandrel stays put inside the case neck while the drill rotates the brass against the cutter for a clean, consistent finish.



Reviews
There are no reviews yet.