$113.95
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Muzzle devices are one of those parts where weight quietly piles up in the worst possible spot on a rifle, way out at the end of the barrel where every ounce feels like three. Griffin Armament went after that problem with this titanium version of their Taper Mount Minimalist Flash Hider. Machined from 6Al-4V titanium, it weighs a scant 1.7 ounces, roughly 60 percent lighter than most comparable suppressor mounts and noticeably lighter than the 2.9 ounce stainless version of the same device. On a lightweight build or a rifle you carry more than you shoot, that difference shows up in how the gun swings and balances.
The three-tine design does a genuinely good job knocking down muzzle flash, and Griffin machined anti-resonance features into the tines so you don't get that annoying tuning fork ping after every shot. Better still, there's no timing required. Thread it on, torque it down, and you're done. No shims, no crush washers, no fiddling with clocking the ports. For a lot of folks that alone makes this the easiest muzzle device install they'll ever do.
This is where the Taper Mount Minimalist earns its keep. The tapered interface gives Griffin taper mount suppressors a rock solid, repeatable lockup with minimal point of impact shift, and it works with the RECCE, Paladin, EXPLORR, Sportsman, and Bushwhacker series cans. Pair it with the Minimalist Blast Shield and it'll run Griffin's pistol suppressors too, plus the Optimus 9 Mid-Size and Optimus Micro with a taper extension. Running it bare? Griffin's Taper Mount Thread Protector snaps over the taper to keep it protected between range trips.
With 5/8×24 threading for .30 caliber barrels, this is a smart pick for AR-10s, bolt guns, and precision builds where you want a suppressor host that doesn't drag the muzzle down. Griffin builds these in-house in Wisconsin and backs them for the life of the product, which is the kind of confidence you like to see in a part that lives at the loudest end of your rifle.
No, and that's one of its best features. Since there are no ports that need to be clocked in a specific direction, you simply thread it on and torque it against the barrel shoulder. No shim kits or crush washers to mess with, which makes installation quick and painless.
It serves as the mount for Griffin's taper mount suppressor lineup, including the RECCE, Paladin, EXPLORR, Sportsman, and Bushwhacker series. It also works with Griffin's Revolution and Resistance pistol suppressors when paired with the Minimalist Blast Shield, plus the Optimus 9 Mid-Size and Optimus Micro with a taper extension. The tapered interface locks up tight and keeps point of impact shift minimal and repeatable.
The titanium version weighs 1.7 ounces versus 2.9 ounces for the 17-4 PH stainless model, so you're cutting over 40 percent of the weight. Griffin puts it at roughly 60 percent lighter than most competing suppressor mounts overall. Since that weight sits at the very end of the barrel, the savings are more noticeable in handling than the numbers might suggest.
Yes. This is a .30 caliber bore device, so smaller projectiles like 6.5mm and 6mm pass through with plenty of clearance as long as your barrel is threaded 5/8×24. Plenty of people run these on 6.5 Creedmoor precision rifles for exactly that reason.
| UPC | 689396838574 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | TMMFHTI5824 |
You must be logged in to post a review.
Reviews
There are no reviews yet.