$109.20
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Most muzzle devices make you pick a lane. Brakes tame recoil but light up the night and rattle everyone next to you. Flash hiders keep your signature down but do nothing for muzzle movement. The Griffin Armament Taper Mount Flash Comp in 7.62mm splits the difference better than just about anything out there, pairing precisely calculated porting that keeps the muzzle flat with flash tines that knock down signature, all in a mid-length package that stays civil on the firing line.
This is the newest generation of Griffin's FlashComp, built off their proven Hammer Comp design and machined from heat treated 17-4 PH stainless steel billet with a durable QPQ finish. The 5/8×24 thread pitch is the industry standard for 7.62 NATO and .30 caliber barrels, so it drops onto most AR-10s, bolt guns, and .308 carbines without drama. A shim set comes in the box, so you can time the ports correctly without hunting down crush washers or peel washers separately.
Here is where this device earns its keep beyond bare-muzzle shooting. The Universal Taper Mount interface gives you a repeatable, rock solid lockup for Griffin suppressors like the Recce, Paladin, Explorr, and Sportsman lines, free of the wear-prone geometry that plagues some quick-detach systems. Even better, the Flash Comp serves as a sacrificial blast baffle, soaking up the worst of the muzzle blast so your suppressor's internals last longer. That is a smart bit of insurance on a can you waited months to take home.
At 2.6 inches long with a 1.075 inch diameter, it keeps a trim profile that will not turn your rifle into a boat anchor. Run it bare and enjoy a flatter-shooting rifle with less flash than a straight brake. Add a Taper Mount suppressor later and the same device becomes your mounting solution. One purchase, two jobs done well, which is exactly what a good muzzle device should be.
It uses Griffin's Universal Taper Mount interface, which pairs with Griffin suppressors like the Recce, Paladin, Explorr, and Sportsman lines that accept Taper Mount accessories. The taper design gives a repeatable lockup without wear-prone latch geometry. If you run a different brand of can, check whether it accepts Griffin Taper Mount devices before ordering.
Both, and that is the whole point. Calculated porting works to neutralize muzzle rise and cut felt recoil, while the flash tines up front trim down the fireball you would get from a pure brake. It will not out-brake a dedicated competition comp or out-hide a dedicated flash hider, but it does both jobs well in one device.
It threads onto any standard 5/8×24 muzzle, which covers most 7.62 NATO and .30 caliber barrels. A shim set is included, so you stack shims to index the ports in the correct orientation rather than using a crush washer. Snug it to spec with a quality wrench and you are set.
When you mount a suppressor over this device, the Flash Comp takes the initial blast that would otherwise hammer your suppressor's first baffle. Since it is machined from heat treated 17-4 PH stainless billet, it shrugs off that abuse and extends the service life of your can. It is cheap insurance for an expensive suppressor.
| UPC | 791154081280 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | TFC762-58 |
| Caliber/Gauge | 7.62MM |
| Color | Black |
| Product Type | Compensator |
You must be logged in to post a review.
Reviews
There are no reviews yet.