$79.00
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Swapping out a front sight base for a clean handguard setup is one of the most common AR-15 upgrades, and the Daniel Defense .750 Clamp Low Profile Gas Block makes that job a lot less nerve-wracking. Instead of relying on set screws that dig into your barrel or taper pins that fight you every step of the way, this block clamps directly onto a .750 gas block seat with a pair of screws. That means no dimpling, no drilling, and no permanent marks on a barrel you probably paid good money for.
The clamp design spreads holding pressure evenly around the barrel rather than pinching it at a couple of tiny contact points. Builders who have run these report solid performance well past a couple thousand rounds without the block backing off or leaking gas, which is the whole point of moving away from set screws. It is machined from 4150 hardened steel and wears a Military Specification Heavy Phosphate Coating, the same tough, corrosion-resistant finish Daniel Defense uses across their barrel and parts lineup.
Coming in at under 2 ounces with a genuinely low profile, this block tucks neatly beneath free float rails. It sits under all Daniel Defense rails with the exception of the MFR rail, and it plays nicely with plenty of aftermarket free float handguards too. Just remember it is non-adjustable, so it is built to run a fixed gas port with a standard AR gas tube.
Installation is about as friendly as gas blocks get. Line up the gas block port with your barrel's gas port (a bent paper clip dropped through both holes is an old builder trick for checking alignment), apply blue thread locker to the clamp screws, and torque them evenly to spec. Match your gas tube length to your barrel's gas system, whether that's carbine, mid-length, or rifle, and you're set for a reliable, low-maintenance build.
Yes, that's the whole idea behind the clamp design. It secures to a .750 barrel seat by clamping down evenly rather than using set screws that need dimples or taper pins that require drilling. Your barrel stays unmarked, which is a big plus if you don't want to modify a quality barrel.
No, this is a non-adjustable block. It runs a fixed gas port and is meant to pair with a properly sized gas port on your barrel. If you want to tune your gas system, you'd want to look at an adjustable model instead.
It sits under all Daniel Defense free float rails except the MFR rail, and it clears plenty of aftermarket free float handguards as well. The low profile height is what lets you run an extended rail over the top. If you're running a specific rail, it's worth double-checking that model's inner diameter clearance.
Align the block's gas port with your barrel's gas port, then apply blue thread locker to the clamp screws and torque them evenly. A bent paper clip dropped through both holes is a simple way to confirm alignment before you tighten down. Make sure you also match your gas tube length to your barrel's gas system, whether carbine, mid-length, or rifle.
| UPC | 815604010122 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 25-079-05006 |
| Shipping Weight | 0.125 |
| Style | Clamp-On |
You must be logged in to post a review.
Reviews
There are no reviews yet.