$83.99
5 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
When you're leaned up against an oak with a longbeard hung up at 40 yards, the tube on the end of your barrel matters more than just about anything else. Carlson's Bone Collector Turkey Choke tightens a 12 gauge Browning Invector-DS down to a .665 constriction, and that snug squeeze is what turns a loose factory spread into a dense, head-and-neck-filling pattern. It's an extended, ported design cut from heat-treated 17-4 stainless steel and wearing a non-reflective matte black finish, so it holds up to hot turkey loads while staying dull enough to keep a wary gobbler from catching a glint.
The magic here is in the parallel section. Carlson's runs a longer taper into the constriction than most factory tubes bother with, and that extra length is what settles the shot column down and cuts out flyers. The result is more pellets landing where you're aiming, shot after shot. Carlson's builds these from corrosion-resistant 17-4 PH stainless, which is a tougher grade than what usually ships in the box with your gun, so it stands up to heavy buffered shells and premium turkey payloads.
This choke is pattern-tested to throw its tightest, most even groups with #4 through #10 shot, which covers pretty much every serious turkey load on the shelf. It plays nice with lead, nickel-plated, copper-plated, bismuth, Hevi-Shot, tungsten, and TSS, so whether you're running budget lead or top-shelf tungsten you've got a tube that'll wring the most out of it. As with any turkey setup, take it to the pattern board with the exact shell you plan to hunt, since different brands and shot sizes will print differently through the same choke.
These are proudly made in the USA and backed by Carlson's lifetime warranty, so if anything ever goes wrong with the tube you just send it back for a replacement. It fits Browning Invector-DS barrels and installs by hand without a wrench, making it easy to swap in for turkey season and back out when you're done.
This tube is cut for 12 gauge barrels that use the Browning Invector-DS choke thread pattern. If your barrel is stamped Invector-DS, this is the right tube. Always double-check your barrel markings before ordering, since Invector-DS and the older Invector Plus threads are not interchangeable.
Carlson's pattern-tested this choke to throw its tightest, most even groups with #4 through #10 shot, which covers the vast majority of turkey loads. It's built to handle lead, nickel-plated, copper-plated, bismuth, Hevi-Shot, tungsten, and TSS. Stick with #4 or smaller for the best results out of this constriction.
No, this choke installs and removes by hand with no wrench required, so swapping it in for turkey season is quick and easy. Just make sure the threads and your barrel are clean before you seat it and snug it down firmly by hand.
Absolutely. Even a pattern-tested choke prints differently depending on the exact brand, shot size, and load you run through it. Take it to the pattern board with the specific shell you plan to hunt with so you know exactly where your gun is hitting at your expected ranges.
| UPC | 723189801809 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 80180 |
| Caliber/Gauge | 12 Gauge |
| Chokes Included | One Choke |
You must be logged in to post a review.
Reviews
There are no reviews yet.