Description
The Burris FastFire Red Dot Mount is a purpose-built plate that lets you pair a FastFire reflex sight with your Ruger Mark I, Mark II, or Mark III pistol. Rather than cutting or milling anything, the mount replaces the factory rear sight and seats into the existing dovetail, giving you a stable, repeatable platform for a red dot. It's machined from aircraft-grade aluminum and wears a flat matte black finish that blends right in with the Ruger's receiver.
How the Burris FastFire Mount Fits Your Ruger Mark
Installation is a straightforward project most owners can handle at the bench. You drift the factory rear sight out of its dovetail, center the supplied dovetail block in the slot, then set the plate and fasten the sight down with the included #6-48 screws to around 12 inch-pounds. Because it anchors to the standard rear sight dovetail shared across the Mark I, II, and III, it's a clean, low-profile setup that keeps your dot sitting nice and far back on the pistol.
What Red Dots Work on the FastFire Ruger Mark Mount
This plate uses the Docter / FastFire optic footprint, so it accepts any generation Burris FastFire, including the FastFire 2, FastFire 3, and FastFire 4. Other optics built on that same Docter-style pattern will index up as well, which gives you flexibility if you already have a compatible dot on hand. Worth noting straight up: this is a mount for non-optic-cut pistols. It's designed for a standard Ruger Mark that still wears iron sights, not a factory optics-ready slide.
For plinking, bullseye work, steel, or just making your trusty .22 easier on aging eyes, a red dot removes the front-and-rear sight alignment from the equation and lets you focus on the target. This mount is the simplest honest-to-goodness way to get there on a classic Ruger Mark without permanent modifications.
Key Specifications
- Manufacturer: Burris
- Manufacturer Part Number: 410329
- UPC: 000381103291
- Fitment: Ruger Mark I, Mark II, Mark III
- Optic Footprint: Docter / FastFire pattern
- Optic Compatibility: Any generation Burris FastFire
- Mounting Style: Rear sight dovetail replacement
- Material: Aircraft-grade aluminum
- Color / Finish: Matte Black
- Optic Cut Required: No
What’s Included
- FastFire mounting plate
- Dovetail block
- Mounting screws (#6-48)
- Torx wrench
Frequently Asked Questions
Will the Burris FastFire mount fit my Ruger Mark I, II, and III?
Yes, this plate is made specifically for the Ruger Mark I, Mark II, and Mark III pistols. It installs into the standard rear sight dovetail those models share, so it's a direct fit for a factory pistol wearing iron sights. Owners have also reported it works on the Mark IV since the rear sight dovetail carries over.
Do I need to mill or cut my slide to use this mount?
No milling or machining is required. The mount replaces your factory rear sight and seats into the existing dovetail, so there are no permanent modifications to the pistol. You simply drift out the rear sight and install the plate with the included hardware.
Which red dot sights work with this FastFire mount?
It uses the Docter / FastFire footprint and accepts any generation Burris FastFire, including the FastFire 2, 3, and 4. Other optics built on the same Docter-style pattern will index up on the plate as well. If your dot uses that footprint, it'll bolt right on.
Is this mount for optics-ready Ruger Mark pistols?
No, this is meant for standard, non-optic-cut pistols that still have iron sights. It works by using the rear sight dovetail, not a factory optics plate system. If your slide already has an optic cut from the factory, you'd want a different plate for that setup.





Reviews
There are no reviews yet.