$195.00
5 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Area 419 built its reputation on muzzle brakes that just plain work, and the Hellfire Match is the sharpest tool in that lineup. This version is cut for 6mm barrels with 5/8-24 threads and comes in a raw stainless finish. It runs on the Hellfire self-timing system, so once your universal adapter is torqued onto the barrel, the brake locks up level every single time with no shims, no crush washers, and no fussing with alignment at the bench.
Where a lot of brakes just stack identical ports and call it a day, the Match takes a different route. It uses a four-port layout where every port is its own animal, with varied lengths, angles, and heights. The idea is that gas pressure and volume change as you move down the length of the brake, so each port is tuned to do the most work at its position. The payoff is strong recoil reduction and controlled muzzle rise without adding extra sound pressure back at your position.
One of the biggest reasons folks stick with Area 419 is the modularity. The same universal adapter that anchors this brake also works with Hellfire suppressor mounts, the standard Hellfire, the Hellfire 2P, and the linear flash suppressor. That means you can swap between a brake and a can on the same rifle in seconds without ever backing the adapter off your barrel. Install is dead simple: torque the adapter down once, left-hand thread the brake and collar on, rotate it level, push it onto the taper, and snug the collar by hand.
This one is bored for 6mm and finished in raw stainless, machined right in Northwest Ohio. Shooters running 6mm cartridges in precision and PRS setups lean on the Match because it keeps the rifle flat and steady enough to call your own impacts. Raw stainless does take a little more elbow grease to clean than the nitride finish since the surface is more porous, so plan on a regular soak in carbon cleaner and you'll keep it running clean for years.
Yes, the standard Hellfire Match brake ships with one Hellfire Universal Adapter in the 5/8-24 thread pitch. The adapter torques onto your barrel and stays put, while the brake locks onto its taper. Just note the adapter comes in a black finish even on the raw stainless brake.
That's the whole point of the Hellfire system. The same universal adapter works with Hellfire suppressor mounts along with the Hellfire, Hellfire 2P, and linear flash suppressor. Once the adapter is on your barrel you can go from brake to can in seconds without any tools or retiming.
The bore on this brake is sized for 6mm projectiles, so it's meant to be run on 6mm barrels like 6mm Creedmoor, 6 GT, 6 Dasher, and similar. Running a bullet larger than the bore is asking for trouble. If you shoot a different caliber, Area 419 offers the Match in other bore sizes.
A little, yes. Raw stainless has a more porous surface than black nitride, so carbon can cling more stubbornly. Soaking the brake in a carbon cleaner and cleaning it on a regular interval keeps buildup manageable, and it'll perform right alongside the nitride version.
| UPC | 810080180598 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 419HFMAT-SS-6-5824 |
You must be logged in to post a review.
Reviews
There are no reviews yet.