$85.99
4 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Mosin Nagant is a rugged piece of history, but that century-old wood and steel buttplate can turn a range day into a shoulder-bruising chore. ATI's MOI0300 Monte Carlo stock swaps all that out for a modern sporter profile that fits the human body a whole lot better. You get a raised Monte Carlo cheekrest that lines your eye up naturally behind a scope, a checkered forearm and grip for a sure hold in the cold or wet, and a recoil pad that soaks up a good chunk of the punch that heavy Russian round is famous for.
The stock is molded from DuPont glass-reinforced polymer, the same tough material ATI uses across its line. It shrugs off scratches, weather, and solvents, and it stays flexible in extreme heat and bitter cold, so it holds up whether you're hunting late-season whitetail or just plinking on a frozen January afternoon. The Scorpion-style recoil pad up top does the heavy lifting on felt recoil, cutting muzzle lift and helping you get back on target faster between shots.
Installation is a genuine drop-in on most rifles. Pull the barreled action from your original wood stock, set it into the ATI shell, and snug down the bottom magazine screw followed by the top receiver screw with a flathead. Plenty of owners have it wrapped up in five to ten minutes with basic tools. That said, the Mosin was cranked out by the millions under wartime conditions, so no two are exactly alike. Some rifles need a little relief work around the receiver or barrel channel, and a 5/16-inch washer comes in the box to help dial in the barrel position. It's designed around round-receiver 91/30 rifles plus M-38 and M-44 carbines, and a little patience with a Dremel goes a long way if yours runs on the tight side.
Two sling swivel studs are already in place, so you can hang a standard sling and head out the door. It's a straightforward, budget-friendly way to modernize a classic warhorse without giving up its character.
It's built for round-receiver 91/30 rifles along with M-38 and M-44 carbines and most 7.62x54R Mosin variants. Because these rifles were produced in huge numbers with plenty of variation, some models may need minor relief work around the receiver or barrel channel to seat cleanly. Hex-receiver rifles in particular tend to run a bit fatter and usually require some trimming to fit.
For most rifles it's a true drop-in job. You pull the barreled action out of the original wood stock, set it into the ATI shell, then tighten the bottom magazine screw and the top receiver screw with a flathead screwdriver. Many owners report having it done in five to ten minutes with basic tools, though rifles that need fitting will take longer.
Yes. The recoil-absorbing butt pad takes a noticeable bite out of the felt recoil compared to the original steel buttplate, which is one of the biggest complaints about a stock Mosin. It also helps reduce muzzle lift so you can settle back on target quicker between shots. Owners consistently note being able to shoot longer sessions comfortably after the swap.
It's molded from DuPont extreme-temperature glass-reinforced polymer, essentially a glass-filled nylon. That material makes it tough against scratches, weather, and chemicals, and it stays flexible in both extreme heat and cold. It's a big step up in durability and weather resistance over aging surplus wood.
| UPC | 758152303004 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | MOI0300 |
| Color | Black |
| Length | 35.9500 |
| Model | |
| Product Type | Stock |
| Style | Monte Carlo |
You must be logged in to post a review.
Reviews
There are no reviews yet.