Description
The stock grip on most AK builds is thin, slick, and about as comfortable as holding a broom handle. The Advanced Technology X1 fixes that with a wider, ergonomically sculpted shape, deep finger grooves, and an aggressive texture that keeps your hand locked in place through a full mag. It's a straightforward upgrade that makes the rifle feel like it was built around your hand instead of the other way around.
What Sets the X1 AK Grip Apart
The standout feature is the built-in X Series recoil-absorbing backstrap. That soft rubber section soaks up the initial shock wave of the shot, cutting down felt recoil and helping keep the muzzle flatter for quicker follow-ups. The front half is firm polymer for a solid, controlled hold while the rear cushions the punch. On a 7.62×39 AK that difference adds up over a long range session, and folks consistently mention less hand fatigue and better control after making the switch.
Built From DuPont Zytel Polymer
ATI molds this grip from DuPont Zytel glass-reinforced polymer, which is the same tough, extreme-temperature material you'll find on quality firearm furniture. It's scratch and weather resistant, shrugs off solvents and gun oils, and won't get brittle in the cold or soft in the heat. This is a part built to outlast the rest of your rifle.
Fitment and Installation on Your AK
The X1 drops onto most stamped AK-47 receivers and variants, and it counts toward your U.S. compliance parts. Installation takes just a couple minutes using the included steel T-nut and steel bolt, though your original mounting hardware works fine too. Snug that bolt down firmly so the grip seats tight and stays put. Worth noting it's designed around stamped receivers rather than milled guns, so check your receiver type before ordering.
Key Specifications
- Manufacturer: Advanced Technology (ATI Outdoors)
- Model: X1
- Manufacturer Part Number: A5102346
- UPC: 758152104533
- Product Type: Finger Groove Recoil Reducing Pistol Grip
- Color: Black
- Finish: Textured
- Material: DuPont Zytel Glass-Reinforced Polymer
- Fitment: Most Stamped AK-47 Receivers and Variants
- Recoil Feature: X Series Recoil-Absorbing Backstrap
- Hardware: Steel T-Nut and Steel Bolt Included
- Origin: Made in the USA
- Warranty: Limited Lifetime Warranty
What’s Included
- X1 AK pistol grip
- Steel T-nut
- Steel mounting bolt
- Installation instructions
Frequently Asked Questions
Will the X1 AK grip fit my rifle?
It's designed to fit most stamped AK-47 receivers and common variants. It's built around stamped guns rather than milled receivers, so check your receiver type before ordering. If you're running a standard stamped AK chambered in 7.62×39, you should be in good shape.
How does the recoil-reducing backstrap actually work?
The rear of the grip uses a soft rubber X Series backstrap that absorbs the initial shock wave of the shot, which is the felt punch of recoil. That helps flatten muzzle lift so you can get back on target faster. The front section stays firm polymer for a solid, controlled hold.
Is the X1 grip hard to install?
Not at all. It goes on in just a couple minutes using the included steel T-nut and steel bolt, or your original mounting hardware if you prefer. Just make sure to tighten the bolt down firmly so the grip seats tight and doesn't wiggle.
What is the X1 AK grip made of and how durable is it?
It's molded from DuPont Zytel glass-reinforced polymer, a tough, extreme-temperature material that resists scratches and weather. It won't be affected by chemicals, solvents, or gun oils, and it holds up in both heat and cold. ATI backs it with a limited lifetime warranty.






Reviews
There are no reviews yet.