$28.16
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you run an L.E. Wilson Case Trimmer and load for the .44 family, this holder is the piece that turns pistol brass prep from a chore into a quick, repeatable step. The QT-44M is designed for rimmed, straight-walled .44 Magnum and .44 Special cases, holding each one square to the cutter face so your trim length stays consistent from the first case to the last.
What sets the Q-Type apart is how it secures the brass. Instead of tapping cases into a standard holder, the Q-Type uses a cross pin that wedges the case in place. A light rap of the pin on the bench clamps it, and another frees it. That design matters with pistol brass because straight-walled cases lack the body taper that makes rifle cases easy to seat, so the pin system saves you a lot of fuss and keeps the case perfectly concentric to the cutter.
Beyond trimming to length, the holder keeps your case aligned for inside neck reaming, case mouth deburring, and military crimp removal. Anything you do on the Wilson trimmer benefits from the brass sitting dead square, and that is exactly what this holder delivers. It is machined from steel and made in the USA, so it holds up to years of bench time.
This one works with the standard Wilson Case Trimmer. One thing worth knowing before you order: the Q-Type holders are not compatible with the Sinclair Sharkfin or the L.E. Wilson Case Holder Clamp, so if your setup relies on those, plan accordingly. For most folks running a Wilson trimmer with .44 brass, though, the Q-Type is the holder to grab whenever it is available. It is the easier, faster way to prep rimmed pistol cases, and it does the job without drama.
It is made for rimmed, straight-walled .44 Magnum and .44 Special brass. Since those cases share the same base and rim dimensions, a single holder covers both. It is purpose-built for the .44 family and should not be used for other calibers.
The Q-Type uses an easy cross pin that wedges the case in place, while standard pistol holders require you to tap each case in by hand. Because straight-walled pistol brass lacks body taper, the cross-pin system is noticeably easier and quicker to load and unload. L.E. Wilson recommends choosing the Q-Type whenever it is available for your cartridge.
No. The Q-Type case holders are not compatible with the Sinclair Sharkfin or the L.E. Wilson Case Holder Clamp. If your trimming setup depends on either accessory, you will want to plan around that before ordering.
Trimming to length is the main job, but it does more than that. Because it holds the case square and concentric to the cutter, it also works for inside neck reaming, case mouth deburring, and military crimp removal on the Wilson trimmer.
| UPC | 815145022196 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | QT-44M |
| Shipping Weight | 0.3 |
You must be logged in to post a review.
Reviews
There are no reviews yet.