$16.99
66 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Buffers don't get a lot of glory, but they do a lot of the heavy lifting when it comes to how your AR-15 actually runs. This White Label Armory carbine buffer is the standard weight option, tipping the scale at 3.0 ounces, which makes it the right starting point for most 16 inch carbine length builds running standard pressure 5.56 or .223 ammo. It's machined to mil-spec dimensions so it drops right into any standard AR15/M16 carbine buffer tube without any fitting drama.
Inside the aluminum body you'll find three steel weights doing the work of soaking up bolt carrier impact and keeping your cycle timing where it should be. That's the same setup that's been proven in these rifles for decades, nothing fancy, just weights and mass in the right spot. The whole thing gets a hard coat anodized black finish that resists wear from the constant back and forth banging it takes shot after shot, so this isn't a part you'll need to think about again once it's installed.
A lot of folks don't think twice about their buffer until something starts feeling off, whether that's sharper recoil, a bolt that locks back inconsistently, or a gun that just doesn't run as smooth as it should. Dropping in a properly weighted, well made buffer like this one is one of the simplest fixes in the AR world, and it's a good move whether you're building from scratch or replacing a worn out factory buffer that's seen better days.
White Label Armory makes this buffer in house in the USA, and it shows in the fit and finish. If you're assembling a carbine length gas system build and want a buffer you can trust to just work, this is a solid, no frills choice that gets the job done without overcomplicating things.
This one is the standard carbine weight at 3.0 oz, built with three steel weights inside instead of tungsten. H and H2 buffers swap in one or two tungsten weights to add extra mass for slowing down an overgassed rifle or running a suppressor. If your rifle is running fine with standard pressure ammo and a typical carbine length gas system, this standard buffer is usually the right call.
Yes, it's machined to mil-spec dimensions so it fits any standard AR15/M16 carbine buffer tube. Just make sure your lower is set up for a carbine length tube and not a rifle length or pistol length tube, since those use different length buffers.
No, this listing is just the buffer itself. You'll need a compatible carbine buffer spring and a carbine buffer tube if you don't already have those on hand.
If your rifle already cycles reliably, locks back on an empty magazine every time, and doesn't feel overly snappy, a standard carbine buffer like this one is all you need. Signs you might want to step up to an H or H2 buffer include harsh recoil, an overgassed feel, or running a suppressor, all of which benefit from the extra mass those heavier buffers provide.
| UPC | 810155160760 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | WLA-BUF-7009-01 |
You must be logged in to post a review.
Reviews
There are no reviews yet.