Tyrant CNC Diamond Cut Takedown Pins – Glock 43/43X/48 Black

Description

There's something satisfying about small upgrades that change how a gun feels every time you pick it up, and this pin set from Tyrant CNC falls right into that category. It's a three piece kit machined from stainless steel and finished in black chrome, designed to replace the plain factory pins on your Glock 43, 43X or 48 with something a little more refined without touching how the gun actually runs.

Diamond Cut Ends on Every Tyrant CNC Pin

Each pin in the set carries Tyrant's signature diamond cut pattern on the exposed ends, which isn't just there for looks. That textured surface gives you a better grip when pushing pins in or out during disassembly, which matters more than you'd think once you're doing it with a punch or even bare fingers. The cut pattern also just looks sharp peeking out from the frame, especially against a black slide.

Stainless Construction Built for the Long Haul

Tyrant bead blasts each pin before plating it in black chrome, which gives the finish some depth instead of a flat coating that wears thin after a few hundred strips. Stainless steel underneath means you're not dealing with corrosion creep over time, even if this gun sees regular carry and cleaning. It's a straightforward material choice that holds up to the kind of repeated handling a subcompact carry pistol goes through.

A Complete Three Pin Replacement Set

This kit covers the locking block pin, the trigger pin, and the trigger housing pin, so you're replacing every pin that's realistically visible or serviceable on the 43/43X/48 platform in one go. They're built as drop-in replacements for the standard grip width, so if your pistol is running a stock backstrap setup these should seat without any fitting. A punch and bench block make the swap easier, but plenty of owners get through it with basic hand tools and a little patience.