$27.99
6 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
There's a reason so many AR builders eventually get around to upgrading their takedown pins, and it usually starts with fighting a stubborn factory pin at the worst possible time. Tyrant CNC built this set to fix that problem for good. Machined from 7075 aluminum and finished with a bead blasted hardcoat anodized black coating, these pins are a mil-spec drop-in fit for standard AR-15 lowers, so there's no reaming, fitting, or head scratching involved. Pull the stock pins, push these in, and you're done.
The standout feature here is the chamfered radius head. Instead of a small flat surface that digs into your fingertip, Tyrant gave these pins a wider, rounded profile that gives you real leverage. That means you can pop your upper and lower apart with your bare hand, whether you're at the bench cleaning your rifle or breaking it down in the field. A chevron cut pattern on the front face adds extra grip texture, and a dimple on the rear head makes it easy to index a punch if you ever do want to use a tool.
Aluminum takedown pins only matter if they hold up, and 7075 is the same grade used in a lot of upper and lower receivers for a reason. It's strong enough to take the constant push and pull of disassembly without wearing out the detent notches or rounding off over time. The hardcoat anodizing adds a layer of scratch and wear resistance on top of that, so the black finish stays looking sharp even after it's been in and out of your rifle a few hundred times.
No special tools or gunsmithing knowledge needed here. These pins are sized to work with any standard AR-15 platform, so you just push out your factory pins, drop in the springs and detents from your old set, and install the new pins the same way. If you run more than one upper receiver or just like being able to break your rifle down quickly for cleaning or transport, this is one of those small upgrades that pays off every single time you touch your rifle.
Yes, these pins are made as a mil-spec drop-in replacement, so they fit any standard AR-15 lower without any modification. You just remove your factory pins and springs and reinstall using the new hardware in the same location.
No tools are required for installation or everyday use. The chamfered head design is actually built so you can push and pull the pins by hand, though the rear dimple is there if you ever want to use a punch for extra leverage.
The factory pins work fine, but they can be tough to grip and remove, especially on a tight fitting receiver set. This set gives you a larger gripping surface and added leverage, so breaking down your rifle for cleaning or storage takes seconds instead of a fight.
Yes, they're machined from 7075 aluminum and finished with a hardcoat anodized coating, which holds up well to the repeated in and out cycling that comes with regular cleaning and maintenance. That combination keeps them from wearing down or losing their finish over time.
| UPC | 612789317431 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | TDAR15TPBLK |
| Model |
You must be logged in to post a review.
Reviews
There are no reviews yet.