$324.99
4 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Diamond is TriggerTech's flagship trigger, and this version is purpose-built for Tikka bolt guns. It brings the same clean, glass-rod break that made the Diamond a favorite in the Remington 700 world over to your T3, T3x, or T1x. If you have ever felt your factory Tikka trigger and thought it could be better, this is the upgrade that shows you exactly what your rifle is capable of once the creep is gone.
What sets the Diamond apart is the patented Zero Creep design paired with Frictionless Release Technology. Instead of relying on polished, lubricated, or coated engagement surfaces like most triggers, the Diamond uses a rolling contact system that removes sliding friction from the release entirely. The result is a break that stays consistent shot after shot, and stays that way after thousands of rounds. The internals are hardened 440C stainless steel, so corrosion resistance and long service life come standard.
Pull weight adjustment runs through TriggerTech's CLKR system, which uses an externally accessible set screw with positive, tactile clicks so you always know where you are. The range spans from under 4 oz up to 32 oz, with fine roughly 0.2 oz-per-click steps in the lighter zone and about 1 oz per click as you move up. That gives competitive precision folks the ultra-light settings they want while still leaving plenty of room for a heavier field-friendly weight.
Installation is about as painless as trigger swaps get. Pull the bolt, remove the stock with the correct Torx driver, and drop the Diamond in place. Most folks have it done in a few minutes with basic tools, and the pull weight can be fine-tuned without pulling the action back out of the stock. It ships set near the middle of its range, so it is smart to run it a bit before dialing anything way down. This is the flat-lever, right-hand version in a red finish, single-stage throughout.
It is built specifically for Tikka bolt-action rifles, including the T3, T3x, and T1x. It is a direct drop-in replacement for the factory trigger, so no permanent modification to the action is needed. Just confirm your rifle is one of those three models and you are set.
The Diamond adjusts from a hair under 4 oz all the way up to 32 oz using the CLKR set screw. It ships preset near the middle of the range, and TriggerTech recommends getting some trigger time before dialing it way down. Ultra-light settings are great on the bench, but a slightly heavier weight is smarter for field and hunting use.
Not at all. You remove the bolt, pull the stock off with the correct Torx driver, and swap the trigger in place. Most folks finish the job in a few minutes, and the pull weight adjustment screw stays accessible so you can fine-tune without taking the action back out of the stock.
The Diamond is the top-tier model with a wider, lighter adjustment range starting under 4 oz, aimed at competition and precision work. The Special covers roughly 1 to 3.5 lbs and leans more toward hunting and general use. Both use the same zero-creep, frictionless release, but the Diamond gives you the lightest settings and the crispest break in the lineup.
| UPC | 885768004114 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | TI0-SRB-02-TNF |
| Color | RED |
| Length | 5.4500 |
| Model | |
| Product Type | Trigger |
| Shipping Weight | 0.331 |
You must be logged in to post a review.
Reviews
There are no reviews yet.