Timber Creek Enforcer Cantilever Scope Mount 34mm Black Aluminum

Description

Getting a scope to sit right on an AR is one of those little battles every builder runs into. Short flat-top rails and collapsible stocks leave you craning your neck or fighting for eye relief, and that is exactly the problem the Timber Creek Enforcer solves. This one-piece cantilever mount clamps entirely to the receiver while reaching the rings forward over the handguard, so your 34mm optic lands right where your eye wants it without any awkward guesswork.

Where the Enforcer Cantilever Mount Earns Its Keep

Built from 6061 aircraft-grade aluminum, the Enforcer keeps things light without giving up strength. The forward offset gives you room for larger objective bells and roomier eye relief, which matters a lot with today's LPVOs and higher-magnification variable scopes. Because everything sits on the receiver as a single rigid bridge, you sidestep the alignment headaches and zero shifts that come with running two separate rings split across a receiver and handguard.

Locked Down and Built to Stay Put

The mount grabs any Mil-Spec Picatinny rail with four Torx clamping screws, and those screws pull double duty as recoil lugs to keep the whole assembly rigid against the rail. Torx heads throughout mean you are not stripping fasteners during install or torquing to spec. The 1.5-inch ring height is the industry standard for a reason, giving you a natural cheek weld on most AR setups with plenty of clearance under the objective for larger scopes.

Finish and Fit

Timber Creek is known for clean anodized finishes, and this one comes in a classic black that pairs with just about any build. It is a 34mm mount specifically, so double-check your scope tube diameter before ordering. All the mounting hardware ships in the box, so you can pull it out, mount your optic, torque it down, and head to the range. Whether you are topping a precision AR or a larger-caliber rig, this mount is ready for serious use.