$47.70
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The factory trigger on a Remington 597 tends to feel heavy and a little gritty right out of the box, and that's the exact problem this Volquartsen hammer was built to fix. Swap out the stock hammer for this one and you're looking at roughly a 50% reduction in pull weight, which usually lands you somewhere in the high 2-pound range instead of five-plus. That kind of change makes a real difference when you're trying to hold a tight group off the bench or ring steel at distance.
This isn't a cast or stamped part. It's wire EDM-cut and fully machined from A2 tool steel, then hardened to Rc 58-60 for the kind of durability that holds its edge over thousands of rounds. The hammer notch is individually surface ground to nail down an exact angle of engagement with the sear, and that's where the crisp, creep-free break comes from. A cleaner sear engagement is the whole reason a lighter trigger can still feel safe and predictable rather than sloppy.
It's a drop-in design meant to work in an unaltered factory trigger guard, so there's no stoning or hand-fitting required. It fits every flavor of the Remington 597, whether yours is chambered in 22 LR, 22 WMR, or 17 HMR. You will need to disassemble the trigger group to make the swap, and plenty of folks find a quick YouTube walkthrough helpful the first time around. If you're not comfortable getting inside the trigger housing, a gunsmith can knock it out in a few minutes.
For 597 owners who mostly plink but want the rifle to punch above its weight at the range, this is one of the best bang-for-your-buck upgrades you can make. A better trigger translates to better shooting more directly than almost any other single part.
It reduces the pull weight by roughly 50% compared to the factory hammer, which typically brings a five-plus pound trigger down into the high 2-pound range. Along with the lighter weight, you get a much crisper, cleaner break thanks to the precision surface-ground notch. Most owners describe it as a night-and-day improvement over stock.
No. It's a true drop-in part designed for an unaltered factory trigger guard, so there's no stoning or hand-fitting needed. You will need to disassemble the trigger group to install it, and a lot of folks watch a quick video their first time. If you'd rather not dig into the trigger housing, any gunsmith can handle the swap fast.
Yes. This hammer fits all models of the Remington 597 regardless of chambering, including 22 LR, 22 WMR, and 17 HMR. It's the same drop-in part across the lineup.
It's wire EDM-cut and fully machined from A2 tool steel, then hardened to Rc 58-60. That's a serious step up from the cast or stamped factory part, so it holds its edge and geometry over the long haul. Expect it to keep delivering a consistent, crisp break for the life of the rifle.
| UPC | 810162011321 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | VCRTH |
| Model | |
| Shipping Weight | 0.0375 |
You must be logged in to post a review.
Reviews
There are no reviews yet.