$23.99
25 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Pistol caliber carbines run different than a standard 5.56 AR, and the buffer system is where that difference shows up the most. There's no gas system slowing things down on a blowback PCC, so the bolt and buffer are doing all the work of managing recoil and timing the cycle. TacFire built the MAR049-PCC-A around that reality, pairing a 5.5oz buffer with a Mil-Spec pistol buffer tube so your 9mm build cycles the way it's supposed to instead of slamming and bouncing.
This is a full buffer tube assembly, not just a single part. You get the Mil-Spec pistol buffer tube with a foam insert already installed for cheek comfort, the 5.5oz buffer itself, a carbine length buffer spring, a castle nut, and a standard end plate. The tube and hardware are machined from 6061 T6 aluminum with a black anodized finish, so it holds up to the abuse of regular range trips without chewing through your budget.
A lot of guys try to run their pistol caliber build with a leftover 3oz rifle buffer and wonder why it feels snappy or the bolt won't lock back reliably. Blowback systems rely on bolt and buffer mass, along with spring tension, to control how fast the action opens. The added mass in this 5.5oz buffer slows that bolt velocity down just enough to smooth out the cycle and cut back on the sharp recoil impulse that pistol caliber ARs are known for, without adding so much weight that you run into short-stroking issues.
Installation follows the same process as any Mil-Spec buffer tube, so if you've built an AR before this will feel familiar. The tube threads into the lower receiver, the end plate captures the takedown pin detent and spring, and the castle nut cinches everything down against the receiver face. Since this kit uses a standard end plate rather than a sling loop or QD version, it's a good fit for builders who plan to add their own sling mount setup or aren't worried about a built-in attachment point.
Blowback PCC actions don't have a gas system to control bolt speed, so buffer mass does most of that job instead. The 5.5oz buffer adds enough weight to slow bolt velocity and calm down the sharper recoil impulse that comes with pistol caliber blowback guns, compared to a lighter rifle buffer that can leave the action feeling snappy.
Yes, this kit is designed specifically for AR-15 pattern pistol caliber carbines and fits Mil-Spec receivers. Just keep in mind that buffer weight needs can vary a bit depending on your specific bolt carrier group and spring, so if your build still feels off after installing this you may need to fine tune with a different weight.
It includes the buffer tube, buffer, carbine length spring, castle nut, and standard end plate, which covers the core buffer system. You'll still need a receiver extension wrench for installation and a stock or brace to slide onto the tube, since those aren't part of this kit.
It's there for comfort against your cheek or shoulder when shouldering the gun, and it also helps cut down on the metallic rattle you sometimes get from an empty buffer tube. It's a small detail but makes the tube feel less hollow when you're running the gun hard.
| UPC | 729205964749 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | MAR049PCCA |
You must be logged in to post a review.
Reviews
There are no reviews yet.