$22.95
8 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The factory polymer guide rod in a Gen 3 Glock does the job, but it flexes over time and eventually wears out. Strike Industries built their Modular Guide Rod to fix that with a corrosion resistant SUS303 stainless steel shaft that shrugs off rust, cracks and the fatigue that plagues plastic rods. The result is a recoil assembly with real staying power and a Flat Dark Earth anodized aluminum end cap that gives your build a finished, custom look.
The standout feature here is the threaded end cap. Unscrew it, drop in the spring weight you want, thread it back on and you're ready to run. That means you can fine tune recoil for a suppressor, a lighter competition load, or a heavier defensive round without stocking a drawer full of complete guide rods. It accepts any aftermarket Glock recoil spring along with Strike Industries' own custom weight springs, so you've got plenty of room to experiment.
This rod is sized for Gen 3 Glocks and fits the G17, 17L, 22, 24, 31, 34, 35 and 37 across 9mm, .40 S&W, .357 SIG and .45 GAP. The shaft measures 3.10 inches without shims. The included stainless shims are the key to a clean fit across that spread of slides. Start with the single 0.4mm shim, check function, and adjust from there. The shims also control how flush the end cap sits against the front of the slide, and they even open up compatibility with Strike's Jitter Plug upgrade.
Strike recommends a dab of medium strength thread locker on the end cap threads during assembly so it stays put through recoil cycles. Keep in mind that very light reduced power springs can get finicky in a bone stock gun when running reduced capacity magazines, so match your spring choice to how you actually shoot. Set up right, this is a durable, tunable upgrade that outlasts the OEM piece it replaces.
It's built for Gen 3 Glocks and fits the G17, 17L, 22, 24, 31, 34, 35 and 37. That covers pistols in 9mm, .40 S&W, .357 SIG and .45 GAP. It is not sized for the compact G19 or for Gen 4 and Gen 5 frames.
No, the rod ships without a spring so you can pick the weight that suits your setup. It accepts any aftermarket Glock recoil spring as well as Strike Industries' own custom weight springs. You can reuse your factory spring to start and swap later as you fine tune.
The shims tailor the rod to fit the range of Gen 3 slides it covers and control how flush the end cap sits at the front of the slide. Start with just the 0.4mm shim, check fit and function, then adjust from there. They also make the rod compatible with Strike's Jitter Plug upgrade.
The OEM polymer rod flexes and can crack or wear out over time. This SUS303 stainless shaft resists rust and fatigue for a longer service life, and the threaded end cap lets you change spring weights without buying a whole new rod. A little medium strength thread locker on the cap threads during install keeps everything secure through recoil.
| UPC | 708747547269 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | GMGRSFDE |
| Model | |
| Product Type | Guide Rod |
You must be logged in to post a review.
Reviews
There are no reviews yet.