Description
If you're chasing single-digit velocity spreads and cases that last, neck tension is one of the biggest variables you can control, and this is where a bushing setup earns its keep. This .347 steel neck bushing drops right into RCBS Gold Medal Match Series and MatchMaster bushing dies, letting you fine-tune how tightly the case neck grips the bullet. It's a small part that has an outsized effect on how consistently your ammo shoots.
What the .347 Steel Neck Bushing Does
Instead of relying on a fixed expander ball to set neck diameter, a bushing sizes the outside of the neck to a specific dimension. By swapping to a larger or smaller bushing, you decide exactly how much tension the neck puts on the bullet. That control reduces how much you overwork the brass, which cuts down on case-neck work hardening and stretches out the useful life of your good brass. The self-centering design aligns the bushing with the case neck as it enters, which helps keep runout low and bullets seated straight.
Sizing In on the Right Bushing
There are two easy ways to land on the number you need. Measure the outside neck diameter of a loaded round and subtract about .002 to .003 inch, which leaves roughly .001 inch of spring-back for proper tension. Or measure your neck wall thickness, multiply by two, add your bullet diameter, and subtract about .001 inch. A lot of reloaders keep bushings one or two sizes above and below their target so they can experiment and find the tension node their rifle likes best.
Getting the Most Out of It
These are bare steel bushings, so run your normal case lube to keep things sliding smooth and your necks looking clean. They pair best with quality brass that has consistent neck wall thickness, since uneven necks throw off tension no matter how precise the bushing is. If you're loading for a precision bolt gun or building match ammo, this is exactly the kind of detail that shows up on paper.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 81662
- UPC: 076683816627
- Bushing Diameter: .347 in
- Material: Steel (bare, in-the-white)
- Type: Interchangeable neck sizing bushing
- Design: Self-centering
- Compatible Dies: RCBS Gold Medal Match and MatchMaster bushing dies
- Works With: Full-length and neck sizing styles
- Finish: Black
What’s Included
- One RCBS .347 steel neck sizing bushing
Frequently Asked Questions
What dies does the .347 steel neck bushing fit?
This bushing is made for RCBS Gold Medal Match Series and MatchMaster bushing dies, and it works in both full-length and neck-sizing styles. Redding, Wilson, and Hornady bushings are also cross-compatible with RCBS Gold Medal bushing dies, and the reverse is generally true as well. Just confirm your die is a bushing-style sizer before ordering.
How do I know if .347 is the right bushing size for my load?
Measure the outside neck diameter of a loaded round and subtract about .002 to .003 inch, which accounts for roughly .001 inch of brass spring-back. You can also measure your neck wall thickness, multiply it by two, add your bullet diameter, and subtract about .001 inch. Many reloaders keep a bushing or two on either side of their target so they can test different tensions.
Do these steel neck bushings need case lube?
Yes. They ship in the white as bare steel, so use your normal case lubrication to keep the neck sliding smoothly and to protect the brass. Skipping lube can leave drag marks and make sizing harder than it needs to be.
Why use a neck bushing instead of a standard expander ball?
A bushing sizes the outside of the case neck to a set diameter rather than pulling an expander through the inside, which gives you direct control over neck tension by swapping sizes. It also works the brass less, so your cases hold up longer and stay more consistent. For precision and match shooting, that translates to better bullet grip uniformity and tighter groups.



Reviews
There are no reviews yet.