$20.99
11 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Cant is one of those quiet accuracy killers most folks never think about until they start stretching things out past a few hundred yards. Tilt the rifle even a couple of degrees and your dialed elevation no longer tracks straight up and down, which pushes your bullet low and off to the side. The SME Scope Leveler solves that with a simple offset bubble level that clamps right onto your 34mm scope tube, giving you a clear reference every time you settle in behind the glass.
The idea here is dead simple and it works. An easy-to-see offset level sits just below your line of sight, so you can confirm the rifle is truly level without pulling your eye off the target. That matters more than people realize, since even a small consistent tilt from shot to shot spreads your groups sideways as the range grows. On long shots where you're cranking elevation, this little device does a lot of the heavy lifting toward keeping your holds honest.
SME machined this from anodized aircraft-grade aluminum and finished it in matte black, so it blends right in with a set of traditional rings instead of looking like an afterthought bolted to your rig. It mounts just like a conventional scope ring: the two halves clamp around the tube and lock down with a pair of steel Allen head screws. The hex wrench you need comes in the box, and the reversible design means it sets up cleanly for both right and left-handed shooters.
Best results come from leveling the rifle first, plumbing your reticle to a vertical reference, then rotating the level so the bubble reads dead center when everything else is true. Once it's set, all you do is glance down and confirm the bubble is centered before you break the shot. It's a low-cost, low-profile upgrade that pays off most when you're shooting at varying distances or reaching way out where a degree or two of tilt turns into a real miss.
This model is built specifically for 34mm scope tubes. It clamps directly around the main tube, so make sure your optic has a 34mm body before ordering. If you run a 30mm or 1-inch tube, you'll want the matching SME version instead.
Not at all. It mounts just like a standard scope ring, with two halves that clamp around the tube and lock down using two steel Allen head screws. The hex wrench you need is included, so you can have it on and rotated to level in just a few minutes.
For close, casual shooting your eye can usually keep the reticle level enough on its own. But once you start reaching out and dialing elevation, even a couple degrees of tilt can push your bullet noticeably left or right and low. This leveler gives you a reliable visual check so cant stops being a mystery variable in your misses.
Yes. The design is reversible, so it sets up cleanly for both right and left-hand shooters. You just orient the offset level where it's easiest for you to glance at from your normal shooting position.
| UPC | 888151017869 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | SMELVLSCP34 |
| Model | |
| Product Type | Scope Leveler |
You must be logged in to post a review.
Reviews
There are no reviews yet.