Description
If you run a Forster Co-Ax press, you already know the spring-loaded universal jaws cover just about every common case out there. But every once in a while a non-standard or hard-to-fit cartridge comes along that the clamshell jaws won't grab well, and that's exactly where the AP1000 adapter plate earns its keep. It swaps out the floating jaw setup for a flat plate that accepts any standard, caliber-specific shell holder you already have in your bench drawer.
What the AP1000 Adapter Plate Does
This plate converts your Co-Ax to accept conventional-style shell holders, the same ones made by Forster, RCBS, Redding, Hornady, and others. It's machined from high alloy steel and made in the USA, so it holds up to the real leverage the Co-Ax puts out. Reloaders have used it to make specialty setups work, like RCBS swaging dies, that the stock jaws simply can't accommodate. You supply your own shell holder, lock it in with the set screw, and you're loading.
Getting the Co-Ax Adapter Plate Installed
Installation is about as straightforward as it gets. You pull the lower shell holder jaw subassembly, move the two button head screws over to the adapter plate, bolt the plate onto the press, then snug your shell holder down with the set screw using a 5/64 Allen wrench. A few minutes at the bench and you're running standard holders. Keep in mind one thing worth knowing: unlike the "S" and "LS" jaws, this plate holds the case fixed rather than letting it float during sizing.
For anyone loading pistol, revolver, wildcat, or other out-of-the-ordinary brass on a Co-Ax, this little plate opens up a lot of flexibility. It's a small piece of kit, but it's one that quietly solves a problem the stock press can't, and it does it without any fuss.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: AP1000
- UPC: 757253200052
- Material: High alloy steel
- Compatibility: Forster Co-Ax Press
- Shell Holder Type: Accepts standard universal shell holders
- Country of Origin: Made in USA
- Installation Tool: 5/64 Allen wrench
What’s Included
- Shell Holder Adapter Plate for Co-Ax Press (AP1000)
Frequently Asked Questions
Does the AP1000 adapter plate come with a shell holder?
No, the adapter plate is sold on its own. You supply your own conventional-style, caliber-specific shell holder to use with it. Standard shell holders from Forster, RCBS, Redding, and Hornady all work.
Which press does this shell holder adapter plate fit?
It's designed specifically for the Forster Co-Ax press. The plate replaces the spring-loaded universal shell holder jaws that come with the press so you can run standard shell holders instead.
Why would I use the adapter plate instead of the stock Co-Ax jaws?
The factory jaws cover most common cartridges, but some non-standard or hard-to-fit cases don't seat well in them. The adapter plate lets you drop in a caliber-specific shell holder for those situations, and it's also handy for specialty setups like certain swaging dies. Just note the plate holds the case fixed and does not let it float like the S and LS jaws do.
Is the adapter plate hard to install?
Not at all. You remove the lower shell holder jaw subassembly, move the two button head screws to the adapter plate, bolt it onto the press, and lock your shell holder in place with the set screw using a 5/64 Allen wrench. The whole swap takes just a few minutes.





Reviews
There are no reviews yet.