$52.99
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you're loading your own 350 Legend and want seated bullets that come out straight and consistent, Redding's standard seating die (part #92791) is a workhorse worth having on the bench. This is the single seating die, not the full three-die set, so it drops right in alongside your sizing and expander dies or replaces a worn stem on your existing setup. It's cut specifically for the 350 Legend straight wall case and threads into any standard 7/8-14 press.
What makes a Redding seating die worth the money is the attention to alignment. The internal bullet guide steers the bullet into the case mouth square, and the built-in crimp ring lets you add a roll crimp in the same stroke if you want it. The proper seat plug comes installed and is shaped to match the bullets most folks run in the Legend, so you get clean contact on the ogive without marring the tip.
These dies are machined in Redding's New York shop and have earned a long reputation among handloaders for tight tolerances and smooth operation. The seating depth adjusts through the threaded stem, letting you fine tune your overall length for your particular rifle and bullet combo. Once you find a load your gun likes, you can lock it in and repeat it.
One of the nice touches here is that the standard seat plug uses 1/2-20 threads, which means you can swap in a Redding bullet seating micrometer down the road if you want micrometer-adjustable depth control calibrated in .001 inch increments. It's a drop-in change, so you're not locked into the standard plug forever. Whether you're loading for deer season or just like tinkering with your own ammo, this die covers the seating side of a 350 Legend reloading setup with the kind of quality that holds up over thousands of rounds.
This is the single standard seating die (Redding part #92791), not the complete three-die set. If you're building a full 350 Legend setup from scratch, you'll also need a full length sizing die and an expander die, since straight wall cases require a separate expanding step. This die is a great choice if you're adding to an existing set or replacing a worn seating die.
Yes. The standard seat plug uses 1/2-20 threads, so you can swap in a compatible Redding bullet seating micrometer as a direct replacement for the original plug. That gives you depth adjustment in .001 inch increments if you want more precise control over your overall length.
It has a built-in crimp ring, so it can apply a roll crimp as you seat if you adjust it to do so. Many handloaders prefer to seat and crimp in one step with a die like this, while others back the crimp out and handle crimping separately for finer control. Either approach works with this die.
It uses the standard 7/8-14 thread, so it fits virtually any common single stage, turret, or progressive press on the market. You'll want a #10 shellholder to run 350 Legend brass through your press.
| UPC | 611760927911 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 92791 |
You must be logged in to post a review.
Reviews
There are no reviews yet.