Redding Standard Seater Die 45-70 Gov’t – Bullet Seating Die 92209

Description

The Redding Standard Seater Die for the 45-70 Gov't is the piece that handles the final, most satisfying step of a reload: pushing the bullet to the exact depth you want. It's a single die built specifically for this straight-wall rifle round, machined from the same heat-treated alloy steel Redding puts into all their tooling. If you've already got a sizer and expander covered and just need a dedicated seater, or you're replacing the one in an older set, this is the straightforward answer.

What the 45-70 Seater Die Brings to the Bench

Inside the die body you'll find a bullet guide, a built-in crimping ring, and the proper seat plug for the 45-70. The bullet guide keeps your projectile aligned as it enters the case, which matters a lot on a fat rimmed cartridge like this one. Everything is cut on Hardinge super-precision lathes and hand polished before it leaves the shop, so threads and internals run smooth from the first stroke.

Seating and Crimping with the Redding Standard Die

Because the 45-70 is a straight-wall case, this seater includes a roll crimp ring built right in. That means you can seat and crimp in one operation when you're running bullets with a cannelure or crimp groove, which is handy for heavy loads and anything headed into a lever gun's tubular magazine. Prefer to crimp separately with a profile crimp die? Just back the body off about a turn and the die seats only, no crimp applied. You control the whole thing with the seat plug and the die body position.

Fit and Setup Notes for the 92209

The die uses an industry standard 7/8-14 threaded body, so it threads into any common single-stage or progressive press. For the 45-70 Gov't you'll want the #18 shellholder, which is not part of this package. Trimming your cases to uniform length and chamfering the mouths beforehand goes a long way toward clean, consistent seating with this die.