Ruger 10/22 Extended Magazine Release – Black (90598)

Description

The factory magazine release on a stock 10/22 gets the job done, but pinching that little latch under the rifle with your thumb and finger slows you down at the range. This genuine Ruger extended release replaces it with a bigger, contoured surface you can work with a single finger, which turns fumbling reloads into a quick, one-motion swap. It's molded from the same heat-stabilized, glass-filled polymer Ruger uses for its trigger housings, so it holds up to real use and blends in like it came on the gun from the factory.

Why the 10/22 Extended Mag Release Earns Its Spot

What sets this one apart from the aftermarket crowd is the balance. It's long enough to reach easily with your trigger finger, but it isn't so oversized that it hangs up on gear or drops your mag by accident. The push pockets are fully ambidextrous, so lefties and righties both get the same clean access, and the flush-fit contour tucks right up against the trigger guard. Folks who run BX-1, BX-25, and the standard Ruger rotary mags consistently find their changes faster, smoother, and more controlled.

Fitting the 10/22 Extended Magazine Release

Installation is a true drop-in job with no modification and no gunsmith required. You pop out the old latch and set this one in its place, which most people knock out in a couple of minutes with a quick reference video if it's their first time. Because it's a Ruger OEM part rather than a third-party knockoff, the fit is dialed in and there's no rattle.

This release fits all 10/22 autoloading rifle models along with the 22 Charger pistol, so whether you're building out a range plinker, a squirrel gun, or a Charger setup, it's a low-cost upgrade that pays off every time you swap a magazine. Made in the USA.