Description
When the geese are working high or the ducks are riding the wind on big open water, a stock choke usually leaves too many gaps in the pattern. The RR3 Raptor is Rob Roberts' answer for that longest-range work, engineered to hold a tight, dense core downrange so you're putting more pellets where the bird is. It threads into Browning and Winchester Invector shotguns and is machined from 17-4 PH U.S. stainless steel, so it shrugs off the moisture and grit that comes with a day in the marsh.
What Sets the RR3 Raptor Apart
The Raptor Series was built off the same thinking as Roberts' well-known Triple Threat chokes, but with newer internal geometry that produces a hotter core pattern. Instead of traditional knurling, these carry machined claw marks and an E-Series Cerakote finish, so they look the part and grip well when you're spinning them in with cold hands. The internal cuts are the real story here, tuned to knit steel and other non-toxic loads into a consistent pattern with less stringing and fewer flyers.
Getting the Most From the RR3 Raptor
Think of this as the tightest choke in a three-piece system: the RR1 handles close decoy work, the RR2 covers mid-range, and the RR3 is the one you reach for when birds are stretching out to the far side of the spread. It pairs especially well with heavier steel payloads, and Federal even developed its Rob Roberts Raptor Steel loads specifically to run through these chokes. As with any long-range choke, it pays to pattern it on paper with the loads you plan to hunt so you know exactly where your effective range ends.
One thing worth noting for the over/under crowd: because of how the RR3 is designed, it goes in one barrel only, not both. For pump and semi-auto guns, it drops right in and gets to work.
Key Specifications
- Manufacturer: Johnny Stewart
- Model: RR3 Raptor
- Manufacturer Part Number: 200281
- UPC: 810174901900
- Gauge: 12 Gauge
- Thread Pattern: Browning/Winchester Invector
- Material: 17-4 PH U.S. Stainless Steel
- Intended Range: Long range
- Best Use: Waterfowl, geese and open-water ducks
- Finish: E-Series Cerakote with machined claw marks
- Series: Raptor Series
What’s Included
- RR3 Raptor Invector choke tube, 12 gauge
Frequently Asked Questions
What shotguns does the RR3 Raptor Invector choke fit?
This choke uses the standard Browning/Winchester Invector thread pattern, so it fits shotguns cut for that system. Always match the choke's thread pattern to your barrel before installing. If your gun uses Invector Plus, Mobil, or another pattern, you'll want the matching version of the RR3 instead.
When should I reach for the RR3 instead of the RR1 or RR2?
The RR3 is the tightest choke in the Raptor lineup and is built for the longest shots. Grab it when you're after geese or ducks working the far edge of the spread and open water. The RR1 is better for close decoy work and the RR2 covers mid-range distances.
Can I shoot steel and other non-toxic loads through the RR3 Raptor?
Yes, the internal geometry is designed to pattern steel and approved non-toxic shot well. Federal even worked with Rob Roberts to develop its Raptor Steel loads specifically for these chokes. For the tightest patterns, run it on a patterning board with your chosen load to confirm your effective range.
Does the RR3 Raptor work in an over/under shotgun?
It does, but because of the way the choke is designed it can only go in one barrel, not both. Pump and semi-auto shooters can install it without any concerns. Either way, it's worth patterning to see how it performs with your specific setup.




Reviews
There are no reviews yet.