$81.99
4 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
When the birds are flushing at your feet or the clays are screaming past inside 25 yards, you want a pattern that opens up quick and stays even. That is exactly what the Rob Roberts T1 Triple Threat delivers. Roberts skips the old choke labels on purpose, but for reference the T1 sits right around a skeet constriction, which makes it the go-to tube for skeet, teal, quail, and tight decoy work over the water.
This is a short-range specialist. The wide, uniform spread gives you a bigger margin for error on birds that break hard and cross fast, so you connect more often instead of shooting around them. Rob Roberts built his reputation testing patterns on computerized analyzers rather than guessing, and the whole Triple Threat line reflects that. The T1 is the open end of the family, with the T2 covering mid range and the T3 reaching out for the long stuff.
Each tube is machined from 17-4 PH American stainless to tolerances well past the usual factory standard. That means it shrugs off the moisture, mud, and grit that come with flooded timber and dove fields, and it holds up to steel, lead, and exotic non-toxic loads. The extended design seats and backs out by hand in most cases and keeps a clean shot release. Each choke carries laser-engraved markings so you always know which tube is in the muzzle.
This version is threaded for the 12 gauge Invector Plus pattern, which covers a long list of Browning and Winchester back-bored guns including the Maxus, Silver, Gold, Citori, Cynergy, BPS, and the Winchester SX2, SX3, SX4, SXP, and 101. Just remember that Invector Plus, standard Invector, and Invector-DS are not interchangeable, so double check your barrel before ordering. Get the right thread and this tube will pattern beautifully in a gun that used to spray.
The T1 is the close-range tube in the Triple Threat lineup. It throws a wide, even pattern that works best inside about 25 yards, which makes it ideal for skeet, teal, quail, and birds worked in tight over decoys. If you need more reach, the T2 handles mid range and the T3 covers long shots.
This tube is threaded for the 12 gauge Invector Plus pattern, which fits many back-bored Browning and Winchester guns like the Maxus, Silver, Gold, Citori, Cynergy, BPS, and the Winchester SX2, SX3, SX4, SXP, and 101. Keep in mind that standard Invector, Invector Plus, and Invector-DS are all different and do not interchange. Check the markings on your barrel or the factory tubes before ordering.
Yes. The Triple Threat chokes are approved for steel, lead, and exotic non-toxic loads, so you can run whatever your hunting or clays setup calls for. The 17-4 PH stainless construction is built to take the pressure and stand up to the elements.
Rob Roberts uses his own naming instead of the old choke labels, but the T1 lands right around a skeet constriction. Because it patterns wide and consistent, it gives you a forgiving spread for fast, close targets. Since every barrel is a little different, the real proof is always on the pattern board.
| UPC | 810174900361 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 200127 |
| Caliber/Gauge | 12 Gauge |
You must be logged in to post a review.
Reviews
There are no reviews yet.