Description
The .35 Remington has a loyal following among brush gun hunters, and if you run one you already know factory ammo can be hard to come by and pricey when you find it. Rolling your own is the answer, and this Redding Series B set gives you the two dies you need to do it right. Redding has been building reloading gear since 1946, and that reputation for tight tolerances and clean machining carries right through to this .35 Rem set.
The set contains a full length sizing die and a seating die, both made from steel. The sizing die resizes the entire length of the case back to standard dimensions so your reloads chamber reliably in any .35 Remington, and it includes a decapping rod assembly with a neck expander button to knock out the spent primer and open the neck in one stroke. The seating die handles the other end of the job with a bullet guide, a built-in crimp ring, and the proper seating plug for the cartridge.
What the Redding .35 Rem Die Set Brings to Your Bench
Every Redding die is hand polished for smooth operation, runs through a final inspection, then gets ultrasonically cleaned before packaging. The bodies use the industry standard 7/8-14 thread, so this set drops into just about any single stage, turret, or progressive press without fuss. The seating die can also apply a roll crimp when you need one, which is handy for tubular magazine lever guns that are common in this caliber.
Getting the Most From the Series B Set
The box itself doubles as a loading block and storage tray, and inside you'll find a spare decapping pin, a hex wrench, and a spot to tuck your shellholder. Keep in mind a shellholder is not included, so you'll want the correct one on hand along with case lube to keep things sliding smoothly and save wear on your brass and press. Set up right, these dies will turn out consistent, good shooting .35 Remington ammo for years.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 80165
- UPC: 611760801655
- Caliber: .35 Remington
- Die Series: Series B
- Set Type: Full Length 2-Die Set
- Case Type: Bottleneck
- Number of Dies: 2
- Material: Steel
- Thread: 7/8-14
- Seating Die: Seat and crimp with bullet guide
- Press Compatibility: Single stage, turret, progressive
What’s Included
- Full length sizing die with decapping rod assembly and neck expander button
- Seating die with bullet guide, built-in crimp ring, and proper seating plug
- Spare decapping pin
- Hex wrench
- Storage box that doubles as a loading block with a spot for your shellholder
Frequently Asked Questions
Does the Redding .35 Remington die set come with a shellholder?
No, a shellholder is not included with this set. The box has a spot to store one, but you'll need to buy the correct shellholder for the .35 Remington case separately. Most reloaders already have a selection on hand or pick one up at the same time.
Will this Redding Series B set work on my press?
Yes. All Redding dies use the industry standard 7/8-14 threaded bodies, so this set fits just about any single stage, turret, or progressive press on the market. It's primarily set up for single stage loading, though bottleneck calibers run fine on progressives too.
Can the seating die apply a crimp?
It can. The seating die has a built-in crimp ring, so you can seat and crimp in the same step if you want. That's a nice feature for the .35 Remington since a lot of these run through tubular magazine lever guns that benefit from a good crimp.
What does Series B mean on a Redding die set?
Series refers to how Redding groups calibers by popularity and production volume. Series A covers the most common cartridges, while Series B through D cover progressively less common ones. The .35 Remington falls into Series B, but the dies themselves are built to the same quality standards across the lineup.



Reviews
There are no reviews yet.