Description
Case mouth expansion is one of those steps that quietly makes or breaks a loading session, and Redding's Premium Expander Die for .40 S&W / 10mm Auto takes it seriously. Rather than just opening the case so a bullet drops in, the expander plug does a series of jobs as it travels through the neck, truing the case internally and setting the stage for a straight, well-aligned seat.
The heart of this die is the TiN-coated expander plug. Titanium Nitride is the same hard, slick industrial coating you'll find on quality machine tooling, and here it adds surface hardness and lubricity while cutting down on the brass build-up that normally cakes onto an expander during long runs. That matters most if you're feeding a progressive press hundreds of rounds at a sitting.
What the Redding Expander Plug Actually Does
The plug works in stages. It starts with a radius on the base that eases entry into the case mouth, then a parallel expanding section trues the inside of the case and creates a clean bearing surface for the bullet, which also gives you more uniform bullet pull and start pressure. A small step aligns the bullet with the centerline of the case, and a final flare can open the mouth a touch more when you're running cast or lead bullets so you don't shave material on the way in.
Fitting the .40 S&W / 10mm Die Into Your Setup
This die handles both .40 S&W and 10mm Auto since they share case dimensions, and it threads into any standard 7/8-14 press. The tapered lead-in makes it right at home on high-volume progressives, but it works just as well on a single stage if you load in smaller batches. It's machined in the USA and backed by Redding's reputation for tight, repeatable tooling, so it slots right in alongside your existing sizing and seating dies.
Whether you're loading jacketed target rounds or powder-coated cast for plinking, a dedicated expander step like this helps keep your seated rounds concentric and your brass lasting longer.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 96253
- UPC: 611760962530
- Caliber: .40 S&W / 10mm Auto
- Die Type: Premium Expander Die
- Expander Plug Coating: Titanium Nitride (TiN)
- Thread Size: 7/8-14 (standard press)
- Country of Origin: Made in USA
- Shipping Weight: 0.53 lbs
What’s Included
- Redding Premium Expander Die for .40 S&W / 10mm Auto
- TiN-coated expander plug
- Plastic storage case
Frequently Asked Questions
Does the Redding Premium Expander Die work for both .40 S&W and 10mm Auto?
Yes. The .40 S&W and 10mm Auto share the same case dimensions, so this single die covers both cartridges. You just set it up once for your press and it handles either round.
What makes the TiN-coated plug better than a standard expander?
The Titanium Nitride coating adds surface hardness and lubricity, so the plug slides through the case mouth more smoothly. It also reduces brass build-up on the expander, which is a real benefit if you're running a lot of rounds through a progressive press.
Can I use this expander die with cast or lead bullets?
You can. The final step on the expander plug is a flare that opens the case mouth a little further, which helps prevent lead shaving when you seat cast or powder-coated bullets. For jacketed bullets you typically won't need the extra flare.
Will the Redding Premium Expander Die fit my press?
It uses the standard 7/8-14 thread, so it threads into virtually any common single stage, turret, or progressive reloading press. The tapered lead-in design makes it especially friendly for high-volume progressive setups.



Reviews
There are no reviews yet.