Description
The Redding 73 Style Steel Bushing in .287 is the kind of small part that makes a big difference at the loading bench. It drops into any Redding bushing style neck sizing die and lets you control exactly how much your case neck gets sized down, which means you set the neck tension that works for your load instead of taking whatever a standard die gives you. The bushing is clearly marked with its size, so there is no guessing once you have a few in the drawer.
What the .287 Redding Steel Bushing Does for Your Loads
Neck tension is one of those details that separates factory-grade ammo from the handloads that shoot tiny groups. By picking the right bushing diameter, you give the neck just enough grip to hold the bullet without squeezing the brass more than it needs. That translates to less brass working, longer case life, and the kind of shot-to-shot consistency that shows up on paper. To find your size, measure the outside neck diameter of a loaded round and subtract about one to two thousandths for brass spring-back and bullet grip.
How the 73 Style Steel Bushing Is Built
These are made from heat treated steel, and the sizing surfaces are hand polished to a surface hardness of Rockwell 60 to 62. That polishing cuts down on sizing friction so the neck slides through smooth and even. The outside dimensions are a standard half inch outer diameter by three eighths inch long, which is the same across Redding's bushing lineup, so they swap freely between dies and also interchange with Wilson style bushings.
Fitting the Redding .287 Bushing Into Your Setup
This bushing covers part of Redding's range that runs in one thousandth increments, giving you the flexibility to fine tune tension across a huge spread of calibers. Keep in mind it works inside a Redding bushing style die, so you will need that die and the correct shellholder, both sold separately. If you are already running a Type S die or similar, this bushing is ready to go to work.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 73287
- UPC: 611760732874
- Bushing Diameter: .287 inch
- Style: 73 Style Steel Neck Sizing Bushing
- Material: Heat Treated Steel
- Surface Finish: Hand polished, Rockwell 60-62 hardness
- External Dimensions: 1/2 inch O.D. x 3/8 inch long
- Compatibility: All Redding bushing style neck sizing dies; interchanges with Wilson style bushings
- Size Increments: .001 inch
- Marking: Marked with size identification
What’s Included
- One Redding 73 Style Steel Neck Sizing Bushing in .287 diameter
Frequently Asked Questions
What die does the Redding .287 steel bushing fit?
It fits all Redding bushing style neck sizing dies, including Type S designs. Because it shares the standard half inch O.D. by three eighths inch length, it also interchanges with Wilson style bushings. The die and shellholder are sold separately.
How do I know if .287 is the right bushing size for me?
Measure the outside neck diameter of a loaded cartridge with a precision micrometer, then subtract about .001 to .002 inch. That accounts for brass spring-back and the grip needed to hold the bullet. The result points you to the correct bushing diameter for your brass and bullet combination.
What is the difference between the steel bushing and the titanium nitride version?
Both share the same dimensions and interchange in the same dies. The steel bushing is heat treated and hand polished to Rockwell 60 to 62 for smooth sizing. The titanium nitride version adds a surface coating to increase hardness and further reduce friction, but this listing is the heat treated steel model.
Why use a bushing die instead of a standard neck sizer?
A bushing lets you set exactly how much the case neck is sized down, so you control neck tension instead of accepting a fixed amount. That means less overworking of the brass, longer case life, and better round-to-round consistency. For precision handloaders chasing tight groups, it is one of the simplest upgrades you can make.





Reviews
There are no reviews yet.