Description
Serious handloaders know that neck tension is one of the biggest levers you can pull for consistency, and that's exactly what this .274 bushing is built to control. This is the heat-treated steel version of Redding's neck sizing bushing, machined to a .274 inch inside diameter so you can size necks down to just the right amount without working the brass more than it needs.
What the Redding .274 Steel Bushing Does
Rather than sizing the neck all the way down and then expanding it back up like a standard die, a bushing setup lets you size the neck to one specific dimension. By picking the correct bushing, you get just the right amount of neck tension to hold the bullet securely without overworking the brass. Less overworking means less case runout, longer brass life, and more uniform seating from round to round. Each bushing is clearly marked with its size, so there's no guessing when you pull it out of the box.
Fit and Build of the 73 Style Steel Bushing
These bushings share a standard 1/2 inch outside diameter by 3/8 inch length, which means this one interchanges freely across Redding's bushing-style sizing dies. The steel body is heat treated and the sizing surface is hand polished to a hardness of roughly Rc 60-62, which cuts down on sizing effort and helps the bushing hold its dimension over a long reloading career. It's made in the USA and covers part of Redding's full lineup that runs in .001 inch increments across the caliber range.
To land on the right size for your setup, measure the outside neck diameter of a loaded round with a good micrometer, then subtract .001 to .002 inch to account for brass springback and bullet grip. That .274 lands right in the window for several 6.5mm and 27 caliber loads depending on your brass and bullet combination.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 73274
- UPC: 611760732744
- Bushing Diameter: .274 in
- Material: Heat-Treated Steel
- Surface Hardness: Rc 60-62, hand polished
- Outside Dimensions: 1/2 in O.D. x 3/8 in long
- Style: 73 Style Steel Bushing
- Compatibility: All Redding bushing-style sizing dies
- Country of Origin: Made in USA
What’s Included
- One Redding .274 73 Style Heat-Treated Steel Neck Sizing Bushing
Frequently Asked Questions
Will this .274 bushing fit my Redding die?
Yes. This bushing uses the standard 1/2 inch O.D. by 3/8 inch length and interchanges freely in all Redding bushing-style neck sizing dies. If your die is set up to take bushings, this one drops right in.
How do I know if .274 is the right size for my load?
Measure the outside diameter of a loaded cartridge neck with a precision micrometer, then subtract .001 to .002 inch to allow for brass springback and bullet tension. That result points you to the correct bushing size. The .274 works for several 6.5mm and 27 caliber combinations depending on your brass thickness and bullet.
What's the difference between the steel bushing and the titanium nitride version?
Both share the same dimensions and interchange in the same dies. The steel bushing is heat treated and hand polished to roughly Rc 60-62 to reduce sizing effort. The titanium nitride version adds a surface coating that further increases hardness and cuts sizing friction, which some handloaders prefer when running dry or with certain brass.
Why use a bushing instead of a standard neck sizing die?
A bushing lets you size the neck to one precise dimension instead of sizing it down and expanding it back up. That reduces how much the brass gets worked, which helps lower runout, extends case life, and gives you more consistent neck tension round to round.



Reviews
There are no reviews yet.