Description
Neck tension is one of those little details that separates ho-hum groups from the kind that make you double check your target. The Redding .244 heat-treated steel bushing gives you direct control over it. Instead of sizing the whole neck down and springing it back out with an expander ball, a bushing die lets you set the exact amount of grip on the bullet, and this .244 diameter is a popular choice for folks loading .22-250 and other .224 bullet cartridges.
Like the rest of the Redding lineup, this one is machined from heat-treated steel, then the sizing diameter gets hand-polished to a surface hardness of Rc 60-62. That polish does two things: it cuts down the effort it takes to run brass through the die, and it keeps the bushing holding its size through a long reloading life. The .244 marking is clearly stamped on the bushing so there's no squinting or guessing when you've got a handful of them in the tray.
Where the .244 Redding Steel Bushing Fits
It carries the standard Redding footprint, 1/2 inch outside diameter by 3/8 inch long, so it drops straight into any Redding bushing-style neck sizing or full-length die. These dimensions also interchange with Wilson-style bushings, which is handy if you've already got a setup built around that pattern. Redding makes the full range in .001 inch steps, so once you know your number you can fine-tune up or down without reworking anything.
Picking the Right Bushing Size
Getting the size right is simple. Measure the outside diameter of a loaded cartridge neck with a seated bullet using a good micrometer, then subtract about .001 inch to account for brass springback while leaving enough grip to hold the bullet. That final number is your bushing size, and if it lands on .244 you're in the right place. Many reloaders keep a couple of neighboring sizes on hand to tweak tension for different bullets or brass lots.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 73244
- UPC: 611760732447
- Bushing Diameter: .244 in
- Material: Heat-Treated Steel
- Surface Hardness: Rc 60-62, Hand-Polished
- Outside Diameter: 1/2 in
- Length: 3/8 in
- Compatibility: Redding Bushing-Style Dies, Wilson-Style Bushings
- Type: Neck Sizing Bushing
- Quantity: 1
- Origin: Made in USA
What’s Included
- One Redding .244 Heat-Treated Steel Neck Sizing Bushing
Frequently Asked Questions
What dies does the Redding .244 steel bushing work with?
It fits all Redding bushing-style neck sizing and full-length dies thanks to its standard 1/2 inch outside diameter by 3/8 inch length. Those same dimensions also interchange with Wilson-style bushings, so it slots right into a lot of common setups. Keep in mind the die itself is sold separately.
How do I know if .244 is the right bushing size for my brass?
Measure the outside diameter of a loaded cartridge neck with the bullet seated using a micrometer, then subtract about .001 inch. That gives you the grip needed to hold the bullet while allowing for brass springback. If that math lands on .244, this is your bushing, and many reloaders keep .245 or .246 on hand to fine-tune tension.
What's the difference between the steel and titanium nitride Redding bushings?
Both share the exact same external dimensions and the same Rc 60-62 hand-polished sizing surface, so they interchange freely. The titanium nitride version adds a coating that boosts surface hardness further and reduces sizing friction. This listing is the heat-treated steel version.
Why use a bushing die instead of a standard neck sizer?
A bushing lets you control the exact amount of neck tension on the bullet rather than oversizing the neck and springing it back out with an expander. That means less working of the brass, which can extend case life, and more consistent tension that often shows up as tighter groups on paper.




Reviews
There are no reviews yet.