$35.96
4 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Recover Innovations CC3H-01 is a slick answer to an old problem: your classic 1911 looks great but has nowhere to hang a light or laser. This wrap-around grip and rail system solves that by replacing your factory grip panels with a molded polymer unit that adds a full-length MIL-STD-1913 Picatinny rail under the dust cover. It bolts right onto standard-frame 1911s using your existing grip screws plus a little extra hardware, so you keep your original pistol exactly the way it is.
The whole kit is molded from glass-reinforced polymer, the same tough stuff a lot of pistol frames are made from, and it comes in at right around 60 grams so it won't throw off the balance you're used to. It keeps the grip roughly the same thickness as standard panels while adding an aggressive serrated texture along the front strap for a more secure hold. Reviewers who've run lights on it note the rail holds steady and the controls line up cleanly, with generous cutouts behind the mag release for both standard and ambidextrous setups.
Installation is genuinely quick. You unscrew your old grips, line up the new panels, thread the grip screws part way, then secure the rail and trigger guard section with the supplied bolt, nut, and hex key before tightening everything down. Most folks have it done in under three minutes with no filing or fitting on a typical frame, and the system stays field strip compatible so you don't have to pull the grips to clean your gun.
This one is built for full-size, standard-frame 1911s that don't already have a rail, and it's Commander compatible too. It plays nice with most major brands like Colt, Kimber, Springfield, Ruger, and Smith & Wesson. It will not fit double-stack or compact/Officer's-sized frames, so if you're running a 7-round mag or an 8-rounder that doesn't sit flush, look at the compact CC3C instead. Recover backs it with a lifetime warranty.
It's made for standard full-size 1911 frames that don't already have a built-in rail, and it works with Commander-length pistols too. It fits most major brands including Colt, Kimber, Springfield, Ruger, and Smith & Wesson. It will not fit double-stack or compact/Officer's-sized frames, so if your gun runs a 7-round magazine or an 8-rounder that doesn't sit flush, go with the compact CC3C instead.
No. You remove your factory grip panels and install this in place of them using your existing grip screws plus the included hardware and hex key. There are no permanent modifications to your pistol, and most people have it mounted in under three minutes.
Yes, the system is field strip compatible, so you can break your pistol down for cleaning without removing the grips. That's a nice touch since you set it up once and leave it on.
The rail is molded from glass-reinforced polymer and mounts solidly to the frame, and users report it holds steady with lights and lasers attached. Keep in mind the rail sits a bit lower than a factory-railed frame, so a light mounted here rides slightly under the bore line. For most range, training, and home-defense setups it does the job well.
| UPC | 7290016552065 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | CC3H01 |
You must be logged in to post a review.
Reviews
There are no reviews yet.