Description
If you shoot 7mm Rem Mag out of a single rifle and you're chasing better brass life and tighter accuracy, neck sizing is where a lot of reloaders land. This RCBS Neck Sizer Die works the case neck and nothing else, leaving the body and shoulder exactly as your chamber fire-formed them. The result is brass that fits your rifle like it was made for it, because in a sense it was.
How the RCBS Neck Sizer Die Earns Its Keep
The die squeezes the neck back down just enough to grip a fresh bullet with the right tension, then the built-in expander-decapping unit opens the mouth to final dimension and punches out the spent primer in the same stroke. Because the shoulder and body never get worked, your brass doesn't stretch the way it does with full-length sizing. Less working of the metal means fewer trims, slower case growth, and more loadings out of every piece of brass. Serious handloaders tend to see the payoff on the target too, since minimal sizing keeps case-to-chamber fit nice and tight.
What Comes with the 7mm Rem Mag Neck Sizer
This is a single die, not a two-die set, so plan on pairing it with a seating die to finish your rounds. It uses the common #4 shell holder, which is sold separately if you don't already have one on the bench. Most folks keep a full-length die around too for the occasional case that needs its dimensions reset for smooth chambering, and this neck sizer fits right into that rotation.
Built to RCBS Standards
The body is machined from steel and threaded in the standard 7/8-14 so it drops into just about any single-stage press you've got. RCBS backs it with their lifetime warranty, and these dies have a long reputation for outliving the presses they get run in. It ships in the familiar green box with a load data sheet tucked inside.
Key Specifications
- Brand: RCBS
- Caliber: 7mm Remington Magnum
- Die Type: Neck Sizer Die
- Configuration: Single die (not a set)
- Expander-Decapping Unit: Included
- Material: Steel
- Thread Size: 7/8-14
- Shell Holder: #4 (sold separately)
- Country of Origin: Made in USA
- Warranty: RCBS Lifetime Limited Warranty
- Manufacturer Part Number: 13630
- UPC: 076683136305
What’s Included
- RCBS Neck Sizer Die (7mm Rem Mag)
- Expander-decapping unit
- Load data sheet
Frequently Asked Questions
Is the RCBS 7mm Rem Mag Neck Sizer Die a complete die set?
No, this is a single neck sizing die, not a two-die set. It handles neck sizing and decapping, but you'll need a separate seating die to finish loading your rounds. Many reloaders also keep a full-length die on hand for the occasional case that needs its body and shoulder reset.
Why would I neck size instead of full-length size my 7mm Rem Mag brass?
Neck sizing only works the case neck and leaves the fire-formed shoulder and body alone, so the brass stays matched to your chamber. That tighter fit tends to improve accuracy and extends case life because the metal isn't being worked as hard each cycle. It works best with brass that's always fired in the same rifle.
What shell holder does this die use?
The 7mm Rem Mag Neck Sizer Die uses the #4 shell holder. Shell holders are sold separately, so grab one if it's not already on your bench.
Does the RCBS Neck Sizer Die remove the old primer?
Yes. The die comes with an expander-decapping unit that punches out the spent primer and sets neck tension in the same stroke you size the neck. You get sizing and decapping handled in one pass.




Reviews
There are no reviews yet.