Description
Every reloader eventually loads a round that needs to come apart, whether it's a wrong powder charge, a flipped primer, or just a load you want to rework. This RCBS collet is the piece that makes a press-mounted takedown possible for .35, .38 and 9mm bullets. It drops into the RCBS Standard Bullet Puller body and locks onto the bullet so the case can be pulled away cleanly, much like a draw collet on a lathe grips a workpiece.
Where the .35/.38/9mm Collet Fits In
This collet is sized for the .357 bullet diameter, which covers a nice family of cartridges. Think 9mm Luger, .38 Special, .357 Magnum, .35 Remington and similar .35 caliber loads. It's built from hardened steel with a gray finish and machined to tight tolerances so it grips jacketed bullets firmly without distorting them. Keep in mind this is designed for jacketed and copper-clad projectiles rather than soft lead.
Threading the Collet Into Your Setup
The RCBS Standard Bullet Puller body uses standard 7/8-14 threads, so it screws into just about any single stage or turret press. Once the body is set up, the process is simple: raise the ram to bring the bullet up into the collet, tighten the collet down with the handle, then lower the ram and the bullet separates from the case. No hammering, no mess, and the powder stays put instead of scattering everywhere like it does with a kinetic puller.
Why Reloaders Keep the Collet Handy
If you break down ammo in any kind of volume, a collet setup is far faster and gentler than banging away with an inertia puller. Folks who've run hundreds of rounds through theirs report bullets coming out firmly with little to no marking. Just remember this is the collet only, so you'll need the RCBS Standard Bullet Puller body to use it, and a separate collet for each bullet diameter you work with.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 9430
- UPC: 076683094308
- Product Type: Bullet Puller Collet
- Caliber: .35 / .38 / 9mm (.357 diameter)
- Compatible With: RCBS Standard Bullet Puller (7/8-14 thread)
- Material: Steel
- Finish: Gray / Silver
- Length: 2.5 in
- Function: Pull jacketed bullets
- Quantity: 1 collet
- Country of Origin: USA
What’s Included
- One RCBS .35/.38/9mm bullet puller collet (collet only, Standard Bullet Puller body sold separately)
Frequently Asked Questions
Does the RCBS bullet puller collet come with the puller body?
No, this is the collet only. You'll need the RCBS Standard Bullet Puller body to actually use it, since the collet installs inside that tool. If you don't own the body yet, pick one up along with this collet.
What calibers will this .35/.38/9mm collet handle?
It's sized for the .357 bullet diameter, so it covers 9mm Luger, .38 Special, .357 Magnum, .35 Remington and other .35 caliber loads. Each bullet diameter needs its own collet, so this one is your go-to for that family of cartridges.
Can I pull cast lead bullets with this collet?
This collet is built for jacketed and copper-clad projectiles like FMJ, JHP and all-copper bullets. Soft lead bullets can deform under the collet's grip, so a kinetic puller is usually the better call for plain cast lead.
Will the RCBS collet damage my bullets or brass?
Used correctly, it grips and releases without wrecking your components, which is the whole point of a collet-style puller over hammering. Some users note it can leave very light marks on the bullet, though many report pulling hundreds of rounds with no real deformation. A thorough cleaning of a new collet helps bullets drop free cleanly.




Reviews
There are no reviews yet.