Description
The .44-40 Winchester is one of those classic cartridges that rewards handloading, and this RCBS 3-die set gives you the tooling to do it right. Built for straight-wall and slightly bottlenecked cases, the set covers every step of the process: sizing, expanding, seating, and roll crimping. If you shoot cowboy action, feed a Model 1873, or run an old sixgun chambered in .44-40, having your own dies means you can tailor loads to your gun instead of hunting down factory ammo.
What the RCBS 18805 Die Set Does
Three dies handle the full job. The steel sizer die resizes the fired case back to spec and knocks out the spent primer with its decapping unit. The expander die opens the case mouth to the correct diameter and adds a light bell so the bullet starts straight without shaving lead. The seater die then seats the bullet to your chosen depth and applies a roll crimp into the crimp groove to lock everything in place. Because sizing and belling happen in separate dies, you get clean, independent control over each operation.
Working With Thin .44-40 Brass
The .44-40 case is known for its thin neck, so a couple of things are worth knowing. This is a steel sizer, not carbide, which means cases need a light coat of lube before sizing. Go easy on it, since too much lube can dent the shoulder. A quick trace of wax or a spray lube wiped off afterward is plenty. Keeping cases trimmed to uniform length also helps you get consistent crimps without crushing a mouth that runs long.
Why Reloaders Reach for RCBS
RCBS dies have earned a reputation for being nearly indestructible and backed by a strong lifetime guarantee. These dies thread into any standard 7/8-14 single-stage or progressive press, so they drop right into whatever setup you already own. For anyone keeping a vintage .44-40 fed, this set is the straightforward, dependable way to load your own.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number (MPN): 18805
- UPC: 076683188052
- Caliber: .44-40 Winchester
- Set Type: 3-Die Roll Crimp Set
- Number of Dies: 3
- Dies Included: Sizer (with decapping unit), Expander, Seater
- Sizer Die Material: Steel
- Carbide: No
- Crimp Style: Roll Crimp
- Case Lube Required: Yes
- Thread: 7/8-14 (standard)
What’s Included
- Steel sizer die with decapping unit
- Expander die
- Seater die with roll crimp
Frequently Asked Questions
Do I need to lube cases with this RCBS .44-40 die set?
Yes. The sizer in this set is steel rather than carbide, so .44-40 brass needs a light coat of case lube before sizing. Use just a trace, since the thin .44-40 case can dent if you apply too much. Wipe the lube off after sizing and before seating bullets.
What does the roll crimp do on this set?
The seater die rolls the case mouth inward into the bullet's crimp groove to hold the bullet securely. A good roll crimp keeps bullets from moving under recoil, which matters in tube-magazine rifles and revolvers. With the thin .44-40 neck, you only want enough crimp to turn the edge over, not more.
Will these dies work in my press?
Yes. The dies use the standard 7/8-14 thread, so they fit single-stage and progressive presses from RCBS and other common brands. If your press takes typical reloading dies, this set threads right in.
What bullet diameter should I use with .44-40?
The .44-40 was originally designed around .427 to .428 inch bullets, and cast bullets in that range are the common choice. If you plan to run larger diameter bullets, check your expander against bullet size, since the thin case mouth can crush if the mouth isn't opened enough. Keeping cases trimmed to uniform length also helps you get clean, consistent crimps.




Reviews
There are no reviews yet.