Description
The RCBS 16301 is a Group A full-length two-die set dialed in for the .338 Winchester Magnum, one of the great all-around magnums for elk, moose, and big bears. It covers the two steps every reloader needs: sizing and seating. The set pairs a full-length sizer die with an expander-decapping unit alongside a seater die with a bullet seater plug, so you can take fired brass all the way back to a loaded round that drops into any .338 chamber.
What the RCBS 16301 Sizer Die Does
The full-length sizer brings your brass back down to SAAMI minimum dimensions, working the outside of the case, knocking out the spent primer, and expanding the neck to grab the next bullet in one stroke. Headspace is held to tight tolerances so the case body length stays consistent through full-length sizing, which keeps your rounds feeding reliably through bolt guns. The die body is vented to let trapped air and extra case lube escape, which helps you avoid dented shoulders during the downstroke.
Seating and Crimping with the RCBS 16301
The seater die uses an adjustable bullet seater plug and has a built-in roll crimp to lock the bullet in place as it's seated. That matters on hard-recoiling magnums like the .338 Win Mag, where you want the bullet staying put in the case neck round after round. You get repeatable seating depth once it's set, so velocities and groups stay honest.
Setup Notes for the RCBS 16301
This is a standard 7/8-14 thread set that fits most single-stage and turret presses on the market. The .338 Winchester Magnum uses an RCBS #4 shell holder, which is not included and sold separately, so grab one if you don't already have it in your kit. RCBS has been building reloading gear for decades and backs its equipment, so this set is made to run for a long time on the bench.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 16301
- Model: Full-Length 2-Die Set
- UPC: 076683163011
- Caliber: .338 Winchester Magnum
- Die Type: Full-Length Sizer / Seater
- Die Group: Group A
- Dies in Set: 2
- Thread: 7/8-14
- Shell Holder Required: RCBS #4 (sold separately)
- Carbide: No
- Gun Type: Rifle
What’s Included
- Full-length sizer die with expander-decapping unit
- Seater die with bullet seater plug and built-in roll crimp
Frequently Asked Questions
Does the RCBS 16301 die set come with a shell holder?
No, a shell holder is not included with this set. The .338 Winchester Magnum uses the RCBS #4 shell holder, which is sold separately. If you already load other magnums like .300 Win Mag or 7mm Rem Mag, the same #4 shell holder covers those as well.
Will the RCBS 16301 fit my reloading press?
Yes, this set uses the standard 7/8-14 thread that fits the vast majority of single-stage and turret presses out there. If your press takes common dies, this set will thread right in.
What do the two dies in the RCBS 16301 set actually do?
The full-length sizer resizes the whole case back to SAAMI minimum dimensions, removes the spent primer, and expands the neck in a single pass. The seater die then seats the bullet to your chosen depth and applies a roll crimp to hold it in place. Together they handle both main steps of loading a finished .338 Win Mag round.
Is this a carbide die set?
No, these are standard steel dies, which is typical for bottleneck rifle cartridges like the .338 Winchester Magnum. You'll want to lube your cases before sizing to keep them running smoothly and to avoid stuck cases.




Reviews
There are no reviews yet.